Bike Forums

Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: ericcc65
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: Bicycle Mechanics
06-06-23, 07:47 AM
Replies: 17
Views: 717
Posted By L134

Are you using caged bearings or loose bearings? ...

Are you using caged bearings or loose bearings? I had this same problem with a Sachs 3 speed IG cassette hub, also with a solid axle. I speculate that I was putting the caged bearings in backwards...
Forum: Bicycle Mechanics
06-05-23, 10:50 PM
Replies: 17
Views: 717
Posted By ThermionicScott

You're tightening each cone against its locknut,...

You're tightening each cone against its locknut, right?
Forum: Clydesdales/Athenas (200+ lb / 91+ kg)
04-09-20, 07:19 PM
Replies: 11
Views: 4,568
Posted By DrIsotope

Unless you're riding to the top of the hill and...

Unless you're riding to the top of the hill and stopping there, it's still going to be 30kcal/mi. Because it might be 60-70kcal/mi on the way up, and 0-20kcal/mi on the way down. Ends up 30 a mile. ...
Forum: Road Cycling
11-13-19, 05:17 PM
Replies: 76
Views: 10,899
Posted By badger1

This. That aside, perhaps folks here don't...

This.

That aside, perhaps folks here don't realize, as said above by sdmc530, that the 'sons [grandsons?] of Walmart' are themselves very, very dedicated cyclists -- especially mtb -- and have...
Forum: General Cycling Discussion
09-19-19, 09:28 AM
Replies: 24
Views: 11,743
Posted By BirdsBikeBinocs

In that case, tighten the bolt. Tension the...

In that case, tighten the bolt. Tension the leather.
Forum: Bicycle Mechanics
07-02-19, 04:16 PM
Replies: 21
Views: 2,231
Posted By noobinsf

You're correct. If this were a 9-speed setup, the...

You're correct. If this were a 9-speed setup, the Dura Ace shifters would work (providing they fit). The 10 speed Dura Ace have the road-specific 10s pull ratio, and you need the mountain 10s pull...
Forum: Bicycle Mechanics
07-02-19, 03:29 PM
Replies: 21
Views: 2,231
Posted By Metaluna

Those are 10sp road shifters. They won't pull...

Those are 10sp road shifters. They won't pull enough cable for a 10sp MTB (aka Dyna-Sys) rear derailleur.
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.