Bike Forums

Bike Forums (https://www.bikeforums.net/forum.php)
-   Hybrid Bicycles (https://www.bikeforums.net/forumdisplay.php?f=290)
-   -   What did you do for your Hybrid today (https://www.bikeforums.net/showthread.php?t=893084)

SpeedRanger 07-02-20 10:25 PM

Replaced Sram Digit 7 brakes with a new set of TRP CX9's


https://cimg2.ibsrv.net/gimg/bikefor...6a06648b92.jpg

Meech33 07-04-20 08:34 PM

https://cimg4.ibsrv.net/gimg/bikefor...8accb7539a.jpg

Meech33 07-05-20 05:33 PM

https://cimg8.ibsrv.net/gimg/bikefor...09467f4472.jpg
Specialized Roll Sport

Jagamov 07-10-20 12:44 PM

Decided a carbon bike needed some carbon parts.


https://cimg7.ibsrv.net/gimg/bikefor...c80cc469a.jpeg
https://cimg9.ibsrv.net/gimg/bikefor...65fc3928b.jpeg

Meech33 07-16-20 06:54 PM

https://cimg3.ibsrv.net/gimg/bikefor...3f06a3461b.jpg

sjanzeir 07-25-20 06:29 AM

I snatched the pair of 700cx28 Vee Road Runners off of my hybridizaed Raleigh Flyer that's temporarily out of commission and - with some difficulty - swapped them in place of the stock 700cx25 Bontrager AW1's on my 17.5-inch 7.6FX.

The transformation in comfort and speed is amazing. I'm looking into getting a second pair for my 15-inch.

The only problem is that the valve stems of the 28mm-compatible tubes that I had lying around were too short, so I had to use the same 20-25mm tubes with 48mm stems that I had. I hope I can get away with that until I get around to buying some tubes!

Saji1965 07-27-20 09:23 AM

Gary Fisher Nirvana
 
Upgraded and tuned my 20 years old Gary Fisher - New rear derailleur, new chain and waxed, all new cables and housing, new grip shifter, new front wheel, overhauled brakes, new brake pads. new rear sprokets, new pedals, new seat post and new saddle.

Loving the ride and so smooth -

jskash 08-04-20 09:27 PM

I brought my Escape back to the LBS one more time to see if they could get the gears to work correctly. They had the bike for three hours. It seemed better when I rode it around the block at the store, but I'll see tomorrow if they got it right this time.

Cornchips 08-05-20 02:24 AM

I installed some MTB pedals on my Giant Escape - all by myself - after watching a few videos on YouTube. I really found the 'step on the wrench' technique very effective it getting the stock pedals off. Apart from that it was pretty easy.

Paid a little bit more than I wanted too at $50AUD, but prices for bikes and parts seem to be a bit distorted at the moment, and I didn't want to wait until COVID passes to get a new set of pedals.


https://cimg8.ibsrv.net/gimg/bikefor...4f85076efb.jpg

spicytomato 08-05-20 04:26 AM

CUBE Cross Pro 2020
The stock pedals it came with, the right pedal in particular, gave in and early, as expected, at 300 km ridden, which leads to annoying sound on nearly every crank turn.
I knew they would not last, just figured they would last longer, lol.

So, today ordered a pair of SHIMANO PD EH500 hybrid pedals, recommended by a fellow experienced cyclist.

Once I get to install them, will start looking for my first cycling shoes.

subgrade 08-05-20 07:03 AM


Originally Posted by spicytomato (Post 21624636)
CUBE Cross Pro 2020
The stock pedals it came with, the right pedal in particular, gave in and early, as expected, at 300 km ridden, which leads to annoying sound on nearly every crank turn.
I knew they would not last, just figured they would last longer, lol.

So, today ordered a pair of SHIMANO PD EH500 hybrid pedals, recommended by a fellow experienced cyclist.

Once I get to install them, will start looking for my first cycling shoes.

Stock pedals usually are indeed a temporary solution, but are you sure the pedal is toast instead of just needing a bit of tightening? Various parts of a new bike may need tightening and/or adjusting after a break-in period.

spicytomato 08-05-20 11:21 AM


Originally Posted by subgrade (Post 21624762)
Stock pedals usually are indeed a temporary solution, but are you sure the pedal is toast instead of just needing a bit of tightening? Various parts of a new bike may need tightening and/or adjusting after a break-in period.


Tightened everything I could. Anyway, I realized I would like to have hybrid pedals quite early on.

sjanzeir 08-05-20 11:31 AM

Moved them out of the way.

Batstar 08-05-20 10:23 PM

Arkel Randonneur Rack
 
I finally got around to fitting an Arkel Randonneur seat post rack on to my Scott Metrix. With its solid, sturdy saddle rail mount and soft seat post clamp, I can attest that this rack is quite rigid, safe and ultra convenient to use. It fits our needs quite well as we have relatively modest carrying requirements. Max weight carrying capacity for the Arkel rack is 6 kgs or 13 lbs. A lightweight roll bag replaces a small Osprey back pack that I’ve been using for longer rides. A center strap with a snap lock secures the bag to the rack and a couple of shock cords with snap hooks keep the ends firmly in place. Best of all, it takes virtually no time at all to install and remove.

https://www.arkel-od.com/arkel-randonneur-rack/


https://cimg4.ibsrv.net/gimg/bikefor...6175abcfd3.jpg
https://cimg5.ibsrv.net/gimg/bikefor...61f2b5511c.jpg
https://cimg3.ibsrv.net/gimg/bikefor...027d6b2709.jpg
This rack also fits neatly on my wife’s Trek FX 5.
https://cimg9.ibsrv.net/gimg/bikefor...22a0d6042f.jpg
https://cimg8.ibsrv.net/gimg/bikefor...f986f22ccb.jpg
The bag accommodates tools/spare tube in a separate mesh compartment while the larger roll top section fits anything from rain gear to snacks and more…
https://cimg6.ibsrv.net/gimg/bikefor...e94a696bc2.jpg

https://cimg7.ibsrv.net/gimg/bikefor...3dfe985fcf.jpg
On rides when I don’t use the rack, my Gamin Varia gets attached to the saddle rails but its position can be easily moved to the tail end of the rack using an affixed mount.

hokiefyd 08-06-20 06:54 AM

That's an interesting rack. I like the bag, too. What bungee straps are you using? Are they integral to the bag or are they separate?

Batstar 08-06-20 09:27 AM


Originally Posted by hokiefyd (Post 21626258)
That's an interesting rack. I like the bag, too. What bungee straps are you using? Are they integral to the bag or are they separate?

Arkel seems to have hit the sweet spot for those who own bikes without mounts or eyelets for racks. Even though it likely won't accommodate panniers due to potential issues with carrying capacity, I think that it does fill a niche market. As for the bag, I actually purchased it on sale from a motorcycle shop and, at the time, it seemed to be the appropriate choice in terms of size and functionality. It doesn’t open at the top as most traditional trunk bags do but the roll top at the end works quite well for me. Having the separate compartment for tools and essentials is a nice touch. I believe that it was meant to be attached to the front fork of a motorbike as it came with two additional straps which were too short for my purposes.I fabricated the bungees to length myself and obtained the hooks and shock cord locally. Even though it does have a central strap and buckle, the bungees prevent the bag from moving laterally.


All times are GMT -6. The time now is 10:12 AM.


Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.