Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Cyclepeasant
Showing results 1 to 7 of 7
Search took 0.00 seconds.
01-02-20, 06:45 PM
Replies: 14
Views: 731
Posted By Cyclepeasant

I wonder if the technician thought you wanted the...

I wonder if the technician thought you wanted the original rim building onto the newer hub? Hence ,new spokes required.
i would still try to get your money back or get the swapping of internals at...
01-02-20, 06:34 PM
Replies: 14
Views: 731
Posted By Cyclepeasant

Unless all the spokes are loose/worn/damaged,I...

Unless all the spokes are loose/worn/damaged,I can't believe they need replacing. A straight swap , check and lube then a roadtest on the bike is all that is required.
i would advise taking it to a...
12-30-19, 03:06 AM
Replies: 14
Views: 731
Posted By Cyclepeasant

Sounds expensive! Don't know what the hourly rate...

Sounds expensive! Don't know what the hourly rate for bike shops is . In UK it's about 30-40p.h.
there is no way it's 3+ hours work.
I can dismantle,clean,,check and regrease an8speed hub in an...
12-29-19, 05:12 PM
Replies: 9
Views: 531
Posted By Cyclepeasant

Is the stem expander bolt hexagon stripped? Or...

Is the stem expander bolt hexagon stripped? Or does it just go round constantly as you try to undo it?
12-29-19, 04:50 PM
Replies: 14
Views: 731
Posted By Cyclepeasant

It is very easy to swap from one hub to another....

It is very easy to swap from one hub to another. As you sit on the bike. It is jus a matter of undoing the left hand cone lock nut and undoing the cone. ( With the wheel removed with the drive side...
12-29-19, 04:29 PM
Replies: 37
Views: 1,990
Posted By Cyclepeasant

Looks like a threaded hole plug. Sometimes on the...

Looks like a threaded hole plug. Sometimes on the inside of the seat stays , just above the weld of the drop out.
12-29-19, 02:35 PM
Replies: 8
Views: 886
Posted By Cyclepeasant

The problem is wear of the PLASTIC sprocket....

The problem is wear of the PLASTIC sprocket. Gates have incorrectly specified the wrong material for the sprocket. At least it should be steel or stainless steel.
i have exactly the same problem...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.