Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: TejanoTrackie
Showing results 1 to 4 of 4
Search took 0.00 seconds.
07-14-20, 10:37 AM
Replies: 11
Views: 815
Posted By TejanoTrackie

Hmmm. I think I’d have a difficult time holding...

Hmmm. I think I’d have a difficult time holding that carbide burr steady enough to avoid slipping and damaging the dropout. But that’s just little old me.
07-12-20, 07:15 PM
Replies: 11
Views: 815
Posted By TejanoTrackie

Could you post a photo of this ? I have grinding...

Could you post a photo of this ? I have grinding stones for my Dremel tool, but they are too wide to fit inside a dropout.
07-11-20, 09:02 PM
Replies: 11
Views: 815
Posted By TejanoTrackie

I donít see how you can cut off the section in...

I donít see how you can cut off the section in the back that is inside the dropout. Please explain.
07-10-20, 07:36 PM
Replies: 11
Views: 815
Posted By TejanoTrackie

If you remove from the rear, you should first cut...

If you remove from the rear, you should first cut off the portion in the front that has a lot of boogered up threads.
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.