Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Search
Notices
Search: Posts Made By: CliftonGK1
Showing results 1 to 8 of 8
Search took 0.05 seconds.
03-19-12, 04:00 PM
Replies: 5,455
Views: 3,892,670
Posted By CliftonGK1

Just finished building up the replacement for my...

Just finished building up the replacement for my previous bike (see thread: "The Death of Strawberry Shartcake" for details)
Here's what I replaced it with; 2011 Redline Conquest Pro... most of the...
09-08-11, 04:00 PM
Replies: 5,455
Views: 3,892,670
Posted By CliftonGK1

I must not have been paying attention. Was this...

I must not have been paying attention. Was this the "B" bike you had at the LD/CX race?
04-24-11, 11:47 AM
Replies: 5,455
Views: 3,892,670
Posted By CliftonGK1

I'm guessing short legs, long arms/torso since...

I'm guessing short legs, long arms/torso since the seatpost isn't jacked up sky high.
04-20-11, 06:16 AM
Replies: 5,455
Views: 3,892,670
Posted By CliftonGK1

It was the Thrilla route; 44/18 gearing. A bit...

It was the Thrilla route; 44/18 gearing. A bit tall for 3 of the climbs, but overall not a bad choice.
04-18-11, 02:27 PM
Replies: 5,455
Views: 3,892,670
Posted By CliftonGK1

Had a chance to get it muddy this weekend on a...

Had a chance to get it muddy this weekend on a local 20 miler loop. Even saw some snow on the trailside as I got up to the top elevations of the ride....
04-06-11, 03:16 PM
Replies: 5,455
Views: 3,892,670
Posted By CliftonGK1

Without being too much of an advert, the rims are...

Without being too much of an advert, the rims are freakin' awesome.
I weigh 230 pounds and put some hurt on a bike. I've been using an old IRO high flange hub on my beater wheelset, so I opted to...
04-03-11, 02:05 PM
Replies: 5,455
Views: 3,892,670
Posted By CliftonGK1

Vassago Fisticuff 60cm frame/fork IRO high...

Vassago Fisticuff 60cm frame/fork
IRO high flange wheelset: Cold Fusion Rims (which are unbadged Velocity Fusions) and IRO high flange hubs on Sapim spokes
WTB A/T 37mm tires for just rolling...
04-03-11, 12:43 AM
Replies: 5,455
Views: 3,892,670
Posted By CliftonGK1

Just finished building. Still need to position...

Just finished building. Still need to position bars and chop steerer, and find my electrical tape to finish the bar wrap properly instead of using painter's tape.
It's a wee bit monstercross-y. :)...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.