Bike Forums

Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: duanedr
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Forum: Framebuilders
02-13-20, 07:19 PM
Replies: 96
Views: 11,373
Posted By duanedr

Make sure you get the one with the roach storage...

Make sure you get the one with the roach storage space at the end!
Forum: Framebuilders
02-11-20, 02:49 PM
Replies: 96
Views: 11,373
Posted By duanedr

I think that will be very nice. Plenty of weight...

I think that will be very nice. Plenty of weight to put pressure on it if you need to and easy to swap in other fixtures like a fork alignment system or stem fixture etc.
Forum: Framebuilders
01-31-20, 07:36 PM
Replies: 96
Views: 11,373
Posted By duanedr

Yes, very much good enough. I'd guess that's...

Yes, very much good enough. I'd guess that's identical to the table I have.
Forum: Framebuilders
01-30-20, 01:02 AM
Replies: 96
Views: 11,373
Posted By duanedr

Interesting. I wasn't really concerned about...

Interesting. I wasn't really concerned about stability in terms of it making a 'flat' surface for measuring but it sounds like you're saying it won't even hold together! I have a hundred or so...
Forum: Framebuilders
01-29-20, 03:50 PM
Replies: 96
Views: 11,373
Posted By duanedr

I believe it's about 8 inches wide and 24 -28...

I believe it's about 8 inches wide and 24 -28 inches long. I'm going off of memory but I don't think that's far off and it's certainly smaller than the 16x35 mentioned. the nice thing about the...
Forum: Framebuilders
01-25-20, 07:41 PM
Replies: 96
Views: 11,373
Posted By duanedr

HA! That is one half of a downtube wrap decal.

HA! That is one half of a downtube wrap decal.
Forum: Framebuilders
01-24-20, 09:23 PM
Replies: 96
Views: 11,373
Posted By duanedr

Here's a picture of my set up as I was drilling...

Here's a picture of my set up as I was drilling it. You can see the puddle of water contained by plumber's putty to keep the bit cool and grinding through. If I was to have a benchtop drill press, I...
Forum: Framebuilders
01-24-20, 10:35 AM
Replies: 96
Views: 11,373
Posted By duanedr

I have a 3'x4'x4" granite plate and drilling the...

I have a 3'x4'x4" granite plate and drilling the granite isn't difficult at all - probably took me 90 minutes to figure out the set up, drill the hole and clean up. I set my drill press up so the...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.