Originally Posted by
frankenmike
Is it possible the roval hubs use a different thru-axle system from the fork? (assuming those wheels didn’t come with the bike.)
Originally Posted by
Iride01
All your stuff is made for the same thru-axle diameter? If you have something made for a 15 mm thru-axle with a bike that has a 12 mm thru-axle, then you'll have play.
I'd check your new stuff with calipers even if the label says the correct diameter. Mistakes happen in packaging and elsewhere sometimes.
There is definitely not a 3 mm gap. besides the old and new sealed bearing cartridges where the same and I run these wheels with out any problem for a few thousand km