These Lasco cranks I bought are said to be JIS taper but even on the shortest JIS spindle I could find (103mm) they sit too far out away from the frame. So I am thinking of going with an ISO taper instead - AKA Campagnolo/italian square taper.
The question is should I get a 103mm wide ISO spindle or will that be too short to the point where the cranks bottom out? I'm trying to get that tucked look against the bb shell.
Has anyone got previous experience with Lasco "track" cranks? I hear that they are machined quite poorly - I wish I knew this when I originally bought them
- hence why they are sitting too far away from where they would ideally be, both for a shorter q-factor and for aesthetic purposes.