Originally Posted by
jgedwa
Wait, something does not make sense here. Has the hub been retro-fitted with a quick-release axle? If so, then drop-out thickness could be an issue. If it is a bolt-on axle, then it would make no difference. I have several ENO hubs and the bolts go all the way in, so even if your dropout was paper thin, it would work.
I am confused by the description of the problem in the OP; can you describe the problem again?
jim
Well, this is my first/only ENO, but it is the Eccentric, so the bolts aren't going into the center of the axle. Even with the wheel off the frame, when I tighten the bolts, they seem to hit a limit, and when I measure the gap, it's 5mm or 7/32" and no, no QR.