Old 06-14-19, 06:06 PM
  #667  
Voodoo76
Blast from the Past
 
Voodoo76's Avatar
 
Join Date: Mar 2005
Location: Schertz TX
Posts: 3,101

Bikes: Ridley Excal, CAAD10, CAAD12, Felt DA, Dolan

Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 170 Post(s)
Likes: 0
Liked 9 Times in 9 Posts
Originally Posted by burnthesheep View Post

One weird thing I've discovered on my DA is that it doesn't seem to fit a very large chainring. My 54T is uncomfortably close to my chainstay.

I wound up custom making a like 1/2 mm spacer for between the crank and BB bearing. I checked everything to try to ascertain why this is. Perhaps it was only ever designed around a 53T ring.

The wide tooth on the narrow wide 1x ring may have added a 1/2 mm or something, but still. I don't understand how this is possible.

It's not possible to "over insert" a crank into the BB bearing is it? I slide it in and give it a slap with my palm to seat it. That's all. When doing that, the 1x big ring pretty much would rub on the chainstay.
What crank are you running? I'm using a Holowgram/SISL2 & can put my little finger between a 56 and the chain stay. A lot of BB30 setups use a drive side spacer (for SISL2 it's 2.5mm) to set the chain line. Could be missing something?

Voodoo76 is offline