Originally Posted by
repechage
That Fixed cup side looks No Bueno to me.
look at the spindle, it is not centered in the cup bore. The cup is tight but the face is off, not perpendicular to the shaft center.
I have seen this, had a bike like this, a Phil Wood fixed the problem, this was before the Edco eccentric lock unit.
Correct. Obviously the cartridge solution wasn't happening, so I went with a cup and cone. Even that is showing askew.
Will bite the bullet and see if an LBS will re-chase the threads and face parallel. The bearings are either grabby with no play, or smooth flowing with lots of play in the spindle.
Thus the reason the frame was $35 plus shipping.