Bike Forums - View Single Post - Building lugged CX/touring bike

07-05-18, 07:40 AM

#23

Saul KK

Member

Join Date: Jun 2018

Location: Melbourne

Posts: 49

Mentioned: 0 Post(s)

Tagged: 0 Thread(s)

Quoted: 5 Post(s)

Likes: 0

Liked 11 Times in 7 Posts

Found some steel pipe that fits pretty well into the BB, squared off the end, and welded it to a plate. Then drilled and countersunk some holes so that I can screw it down to the MDF. I had planned to reference the BB off one of it's faces, but found that they are not parralel to each other.

Roughly shimmed everything up to have a look. Found some pipe that fits nicely into the HT, and figured a wider reference area would mean more accuracy in keeping the HT in line with the ST.

Reply