Originally Posted by
Barry2
Went to install a brake (Shimano 105) on my new carbon fork, only to find that the face of the fork is not square to the mounting hole.
1. Am I being retentive?
2. Do tapered washers exist? I need a 6mm ID washer with a 2mm taper and ~14mm OD
3. I'd mill my own, if I could only think of a way to hold it still in my desktop mill ?
Before you ask... yes I did cheap out on the fork, and got my just deserves.
Barry
There are spherical washers to be had from an Industrial supplier. A set of those should sort it out to your satisfaction.