Thread: Will my classic frame fit a Campi groupset?
View Single Post
Old 05-21-20, 10:17 AM
  #7  
branko_76 
Senior Member
 
branko_76's Avatar
 
Join Date: Jun 2018
Location: The Urban Shores Of Michigami
Posts: 1,749

Bikes: ........................................ .....Holdsworth "Special"..... .......Falcon "Special".......... .........Miyata 912........... ........................................

Mentioned: 11 Post(s)
Tagged: 0 Thread(s)
Quoted: 702 Post(s)
Liked 672 Times in 420 Posts
Cattmann , If you're going to spread the seat/chain stays, you'll need to make sure you check the frame alignment before and after. You check it before in case the stays are already offset. You want the stays to be centered on the head-tube and seat-post. You also want to do it in a controlled manner to avoid over-bending and then having to reverse the bend. I made this simple jig that I attached to the floor so that the frame doesn't bounce around while setting the stays...







branko_76 is offline  
Reply
Likes For branko_76: