Old 06-23-20, 05:14 PM
  #4  
dhub92
Newbie
 
Join Date: Jun 2020
Location: Quito
Posts: 2

Bikes: MTB GER Level 4.5

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Originally Posted by Canker
or just buy a sunrace 12 speed cassette that uses the standard style freehub body
Thanks for your answer. I was searching that cassette but its kind of expensive (about $80-$100) and its smallest cog is still 11t.

Originally Posted by davei1980
That's a really good point but that will limit the OP to a 11t smallest cog, rather than the new 10-51t put out by Shimano.

I was thinking of doing the same thing because I have the Sunrace 12 speed 11-50t but going to a 10-51t would allow me to switch from a 30t to a 28t chainwheel, resulting in a little higher top gear and my low gear would be pretty damn low (good for climbing because I wouldn't be in my largest cog for as long, if ever).

Mind you, I have reallly big 29x3.0 tires so takes a lot of gear reduction to kick those guys over.
Exactly, my current lowest and highest range are: 1.74 and 8.88 meters (wheel diameter: 2.32 m) respectively with my 3x8 configuration so, I want to keep a good high range and have a better low range with the 1 x 12 configuration of the m6100 groupset.

Back to the original question, is it possible to replace the regular HG freehub body (FH-RM35) with the new micro spline body ? what do you guys think ? or, Should I go for the m6000 2x10 (28-38t) instead ?

Last edited by dhub92; 06-23-20 at 05:20 PM.
dhub92 is offline