View Single Post
Old 06-28-20, 07:29 PM
  #2  
Doug Fattic 
framebuilder
 
Join Date: Dec 2009
Location: Niles, Michigan
Posts: 616
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 180 Post(s)
Likes: 0
Liked 211 Times in 106 Posts
Well Tom you already know the basic principles involved that are the same as when you carved your blank lugs. You can start with the same font you used in the down tube lettering. It may have to be enlarged or reduced. A flat piece of stainless plate after cutting can be curved by squeezing between a thick inner steel tube and a slightly bigger outer tube cut in half.
Doug Fattic is offline