View Single Post
Old 05-25-20, 01:33 PM
  #11  
CliffordK
Senior Member
 
CliffordK's Avatar
 
Join Date: Nov 2014
Location: Eugene, Oregon, USA
Posts: 27,600
Mentioned: 217 Post(s)
Tagged: 0 Thread(s)
Quoted: 18321 Post(s)
Liked 4,490 Times in 3,338 Posts
You could probably reduce the thickness of the split ring slightly with a file (or a lathe). You don't want to go to far, but perhaps enough to cut the gap in half. It wouldn't make a big difference, but it might help cosmetically. However, you'd have to be very careful not to significantly taper it otherwise you could damage the headset.
CliffordK is offline