Hiya! I have a couple new questions
going through the Paterek manual again and searching the forums but it’s not obvious to me exactly what to do.
While checking the tubes for straightness I'm guessing that I should orient the convex side upwards for the TT and DT? For the ST maybe it doesn't matter that much if its forward or towards the back?
Also, which side of the tube, in regards to butts of different lengths after mitering, would you orient towards the HT? It’s only my DT that has a marked short side actually, the TT has butts of the same length so I’ll try to make them even I guess. ST is pretty straight forward, only one side will accept a 27.2 seatpost so that should be up
Thanks!