Thread: Rear axle spacing from locknuts
View Single Post
Old 04-05-19, 07:32 AM
  #5  
HillRider
Senior Member
 
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656

Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!

Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times in 742 Posts
The "standard" qr axle protrusion past the locknuts is 5.5 mm on both sides assuming the hub and axle are built for the same OLD. For example, a 130 mm OLD hub would use a 141 mm axle.
HillRider is offline  
Reply