Thread
:
Building lugged CX/touring bike
View Single Post
07-31-18, 07:20 PM
#
44
Saul KK
Member
Join Date: Jun 2018
Location: Melbourne
Posts: 49
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 5 Post(s)
Likes: 0
Liked 11 Times in
7 Posts
Brazing CS's into BB
Brazed up and cooling off
Checking alignment against the SHS. Note the 2 pieces of steel clamped either end of the SHS to keep it square to itself.
Checking the dropouts are centred to the frame. Made sure to flip the frame over and check again, as the CS's sag somewhat under their own weight.
Checking for the correct angle between ST and CS's
Didnt get any photos, but prior to brazing the seat stays in, I had shaped and brazed the end plugs into the tops. Here they are ready to be brazed into the drop out sockets.
Seat cluster pinned, fluxed, and ready for brazing.
Main frame pretty much complete after soaking off the flux and a quick scotchbrite. Still have a whole lot of filing, sanding and clean up to do, as well as adding all the little braze ons, cantilever bosses, and bridges.
Last edited by Saul KK; 07-31-18 at
07:23 PM
.
Reply
Saul KK
View Public Profile
Find More Posts by Saul KK