Bike Forums - View Single Post - Troll Kickstand: A Different Approach
View Single Post
Old 08-10-19, 12:43 AM
  #12  
Bike Jedi
Banned.
 
Join Date: May 2019
Posts: 195
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 87 Post(s)
Liked 8 Times in 8 Posts
There is a guy in the comments on this article pitching his adapter for a rear kickstand:

https://www.cyclingabout.com/best-dy...g-bikepacking/

Kickstand:Pletcher ESGE Comp – $18 on Amazon
I’m a massive kickstand fan. Craig, a Surly and kickstand fan, designed two 3D printed stainless steel parts (part 1 + part 2) that will mount a KSA-18 kickstand onto Surly Troll, Ogre or ECR dropouts. Read more about kickstands HERE.
https://www.amazon.com/gp/product/B0...3067e7facee938

https://www.shapeways.com/product/5W...oll-ecr-part-1

https://www.shapeways.com/product/EF...shop-inventory

I tried ordering them from him but no success. It takes a few weeks to get them. The cost is a bit extreme for my taste compared to the actual cost of the kickstand. I tried placing an order and couldn't get it to go through in the end. So I am not sure what is up, but this is a solution also. Hopefully the guy makes it easier to get your hands on the product or releases the 3D prints to have them submit and printed for ourselves eventually.
Bike Jedi is offline  
Likes For Bike Jedi: