Originally Posted by
79pmooney
OP, you asked about "fork offset" and "rake". Yes, what Trek is calling offset is simply rake. You can see it on the diagram.
Edit: but it is worth checking the actual rake on your fork. Those catalogs typically are printed long before the bikes are made and changes often happen.
Ben
I’ve found the Trek forks to be pretty accurate, of the few I measured. But if this 760 is actually made of 531P (very thin-wall tubes) it is probably seriously intended for racing, and hence should have rather tight wheel clearances. Not sure it can readily be made into anything that isn’t also racy.