View Single Post
Old 01-24-19, 04:40 PM
  #27  
fietsbob 
coprolite
 
fietsbob's Avatar
 
Join Date: Jun 2010
Location: NW,Oregon Coast
Posts: 41,396

Bikes: 8

Mentioned: 188 Post(s)
Tagged: 0 Thread(s)
Quoted: 6917 Post(s)
Liked 244 Times in 202 Posts
back of the envelope design ...

A scheme to add the flanges to a good commercially available sealed bearing pulley , like Tacx , sandwiched between them popped in my mind ,,
the flanges need not be part of the pulley to work as far as I can grasp the mechanics involved..

brass or oil bronze tubing can join the 3 pieces and slide along the pin in the chain tensioner.. as required.. & separate to do the occasional cleaning..

pulley can even turn faster than the flanges.. fixed to the bushing sleeve the bearing rolls around ..





.....

Last edited by fietsbob; 01-24-19 at 04:45 PM.
fietsbob is offline