Originally Posted by
njkayaker
So, your problem isn’t fixed.
I thought you said turning of recalculation fixed it (which I would expect not to work).
However you are loading them, the route files contain the same information.
There is no real difference between using GC or RWGPS.
What map are you using to plan the routes?
Its a case of try a setting, observe results. In this case I turned off Recalculation on both units (based on a recommendation of some reported navigation issues on the Garmin forum), then created a Test course in RWGPS (basic map, 1 mile, 7 turns), did a load via the iQ RWGPS app, which is a .fit file (did this for the 1000 and 1030). Then test drove that route running both devices and had no issues. Then loaded a 28 mile commute route I had in Connect, test drove that course, had no issues on either device. One of the few differences between the test drives and the afternoon bike ride was a car vs. a bike.