Originally Posted by
dsaul
The front end looks good. The saddle height looks low for a 5'8" rider and the standover looks too high, if you have input the correct value for that. I would check on that standover(769mm on the drawing) and change the top tube angle to get some standover clearance.
Hey! Thanks for the feedback. Hmm ok. So, I'm 5'8½" with an inseam of roughly 77.5 cm(measured at home =) ). Going for crank shafts that are 170mm. I measured a couple of my bikes and yes, the saddle height is too low on the drawing, it should be around 660mm. Stand over height on those other bikes are between 770 and 780mm which could be lowered a little of course. What would you have expected those measurements to be?
Thanks!