Old 02-20-18, 06:11 PM
Senior Member
Kontact's Avatar
Join Date: Apr 2011
Posts: 3,597
Mentioned: 32 Post(s)
Tagged: 0 Thread(s)
Quoted: 2146 Post(s)
Likes: 0
Liked 4 Times in 4 Posts
Originally Posted by Doge View Post
Sight unseen - I may be off. But drill through the head tube (as per last post). Go around the steer tube, and take it out right before the seat joint.

I assume you can't take it down the down tube under the BB and to the chain stays. Thought I'd mention.

Do you plan on the housing going in side the frame? Think about smaller holes and stops. There are also stops used for this (for bigger holes) so look for them.
Are you recommending wrapping the brake housing around the steerer tube so it drags? That seems like a terrible idea.

You have to route the housing through the frame, otherwise the brake wire would cut the frame or steerer over time.
Kontact is offline