Bike Forums - View Single Post - Drilling holes for internal brake cable mod
Old 02-20-18, 06:04 PM
  #19  
Doge
Senior Member
 
Doge's Avatar
 
Join Date: Jan 2014
Location: Southern California, USA
Posts: 9,825

Bikes: 1979 Raleigh Team 753

Mentioned: 151 Post(s)
Tagged: 0 Thread(s)
Quoted: 3088 Post(s)
Liked 106 Times in 78 Posts
Originally Posted by scorpiox View Post
... drilling holes into the top tube
Sight unseen - I may be off. But drill through the head tube (as per last post). Go around the steer tube, and take it out right before the seat joint.

I assume you can't take it down the down tube under the BB and to the chain stays. Thought I'd mention.

Do you plan on the housing going in side the frame? Think about smaller holes and stops. There are also stops used for this (for bigger holes) so look for them.
Doge is offline