Fillet Brazing Practice Questions
I was able to figure out Metalgeek! Not bad for someone who still has a challenge turning on my Android tablet and tablet!
So a few questions. Is is ok to go back and add brass to build up a fillet? I did a few and I saw some "skimpy" areas so as I am practicing I cleaned and refluxed and added more brass.
Also I used my homemade sandblast cabinet and cleaned off some painted tubes from donor frames. I then blasted a completed braze joint to see how it would clean up the excess flux. Did a nice job. But is this an acceptable practice?
Ir was nice to be in the shop after snowblowing the drive again!
Thanks!!