Originally Posted by
markg
Since it looks like some of you have already installed the FSA SL-K modular crankset, what the heck is the wrench you use in the self-extractor? I am used to using a 8mm hex wrench on the 24mm allow MegaExo cranks, but the set I received has a 12-point head stamped M18 (parts list says it is QR-19 - something like
this . I have found zero documentation about what bit to use. Looks like a 10mm hex wrench fits, but want to make sure that is what it actually is before i start torquing it down
I had the same question. I think there's a specific bit that you could use if you can find one, but I would have gone with the 10mm hex except that I had some other issues that I wasn't sure of and decided to have my shop install it. I think they only charged $30, which included repositioning and adjusting the derailleur, so I was glad to let them have at it.