All,
I can't get my 1Up hitch pin to engage with the inside of the lock mechanism. The pic below shows as far as it will go in before bottoming out on the internal female threads.
Of course the male screw thread is rectangular as well as the portion you can see right where it inters the lock. I think the non-threaded rectangular portion of the screw is supposed to go all the way in past the lip in the female side so that it can then be turned to engage the internal threads.
Seems that the pin bottoms out on the internal thread before the rectangular piece clears the opening in the lock.
The wheel locks have the same problem.
Any ideas?
Thanks much.
Glenn