Date of Alan frame?
#1
Newbie
Thread Starter
Join Date: Apr 2008
Posts: 32
Likes: 0
Liked 0 Times
in
0 Posts
Date of Alan frame?
Hi, can you tell the date of my Alan bicycle? I cannot find it engraved on the frame. I post a picture of the bottom bracket with dimensions in cm and the serial number, but nothing else. The decal on the seat tube lists the championship victories and says that the last victory was in 1976. So, my frame is not earlier than 1976, but which year exactly?
#2
Senior Member
It has attached rear brake cable tunnels which were reportedly introduced for the 1978 model year. Also, in 1979 they added an open format date code to the top, drive side of the seat tube. It should tell you the exact manufacturing date. If it's not there, then it should be a 1978 by virtue of the cable tunnels. Here's a link to fairly exhaustive ALAN dating guide; https://www.dcisite.be/en/artikel-info/alan-guide
#3
Newbie
Thread Starter
Join Date: Apr 2008
Posts: 32
Likes: 0
Liked 0 Times
in
0 Posts
It has attached rear brake cable tunnels which were reportedly introduced for the 1978 model year. Also, in 1979 they added an open format date code to the top, drive side of the seat tube. It should tell you the exact manufacturing date. If it's not there, then it should be a 1978 by virtue of the cable tunnels. Here's a link to fairly exhaustive ALAN dating guide; https://www.dcisite.be/en/artikel-info/alan-guide
Do I also have the "lethal" fork that was supposedly prone to failure? Mine has a round section, for sure, otherwise I don't know what to look for.
Last edited by kanenas; 11-24-22 at 02:23 PM.
#4
Stop reading my posts!
you may be conflating the "Death Fork" found on many Viscount/Lambert with the ALAN, which is also made of alloy but AFAIK did not have a particular record of catastrophic failure.
YMMV
The "common knowledge" weak point ascribed to many ALAN frames is cracking of the headlugs, always good to make periodic checks of them, may as well extend your check to all other lugs, joints and tubes.
YMMV
The "common knowledge" weak point ascribed to many ALAN frames is cracking of the headlugs, always good to make periodic checks of them, may as well extend your check to all other lugs, joints and tubes.
#5
Senior Member
Join Date: Jan 2019
Location: Netherlands
Posts: 671
Bikes: Especialy Alan, but also Empella, Cascarsi, Gazelle, Bianchi, CJV, Sirocco, Berkers etcetera
Liked 1,001 Times
in
357 Posts
I agree with unworthy1 about the fork.
The first model, the Competition, had a fork with a steel inner tube, the second, yours, had a fork with a alloy inner tube. Maybe here began a story ... ?
The first model, the Competition, had a fork with a steel inner tube, the second, yours, had a fork with a alloy inner tube. Maybe here began a story ... ?
#6
Senior Member
Go to the Alan web site and take a few pictures and ask. They're very responsive.
#7
Senior Member
The cable guides on my bike were introduced in 1978. The numbering on the seat tube was introduced in 1979. Since I don't have numbering, it follows that my bike was produced in 1978. Thank you T-mar!
Do I also have the "lethal" fork that was supposedly prone to failure? Mine has a round section, for sure, otherwise I don't know what to look for.
Do I also have the "lethal" fork that was supposedly prone to failure? Mine has a round section, for sure, otherwise I don't know what to look for.
Likes For gearbasher: