Suspension Fork Tubes ?
#1
Senior Member
Thread Starter
Suspension Fork Tubes ?
Hello.
So question. I am going to replace the fork tubes with longer, about 3 feet, maybe less.
Tubes are 1" with .065 wall. I would like to get stainless, would I get the same size wall. Seamless or Welded?
Yes, I know I need to weld at the bottom to replace. I am good with that.
Thanks.
So question. I am going to replace the fork tubes with longer, about 3 feet, maybe less.
Tubes are 1" with .065 wall. I would like to get stainless, would I get the same size wall. Seamless or Welded?
Yes, I know I need to weld at the bottom to replace. I am good with that.
Thanks.
#2
Senior Member
Join Date: Jan 2013
Location: South Jersey
Posts: 2,266
Mentioned: 18 Post(s)
Tagged: 0 Thread(s)
Quoted: 714 Post(s)
Liked 800 Times
in
475 Posts
Online metals https://www.onlinemetals.com/en/buy/...eel-round-tube
#3
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,073
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4201 Post(s)
Liked 3,856 Times
in
2,305 Posts
While one could just duplicate the current wall thicknesses I would suggest the added leverage of the longer reach will want somewhat thicker walls. I suggest using seamless DOM 4130 cro moly. Andy
__________________
AndrewRStewart
AndrewRStewart
Likes For Andrew R Stewart:
#4
Generally bewildered
Join Date: Aug 2015
Location: Eastern PA, USA
Posts: 3,037
Bikes: 2014 Trek Domane 6.9, 1999 LeMond Zurich, 1978 Schwinn Superior
Mentioned: 20 Post(s)
Tagged: 0 Thread(s)
Quoted: 1152 Post(s)
Liked 341 Times
in
251 Posts
I agree with Andy, and would add this: a butt weld between two tubes leaves the existing tube thickness at the joint. I'd go for thicker walls, and turning the ends of the tube on a lathe to insert the new, thicker tube some distance (a few inches) into the existing tube before welding.
Last edited by WizardOfBoz; 06-30-20 at 02:24 PM.
Likes For WizardOfBoz:
#5
Senior Member
Thread Starter
The angle to the ground will not be extreme. Tubes are being replaced completely. Just welding at the bottom to facilitate the suspension part install.
#6
Senior Member
Thread Starter
So my dad has some 1” pipe. I am going for a sort of cafe race. Maybe shorter.
The pipe he had is too thin, so probably make handle bars if I cannot find what I want.
The pipe he had is too thin, so probably make handle bars if I cannot find what I want.