Tip for Jersey Zipper
#1
Junior Member
Thread Starter
Tip for Jersey Zipper
I’ve had the zipper slider break on almost every Jersey that I’ve owned despite following the manufacturers recommended washing instructions. To save from repeatedly repairing the zipper, since my jerseys are full zipper and there is no need to zipper them completely open, I just zipper them halfway open and slip them on and off over my head.
Likes For hrdknox1:
#2
Senior Member
Join Date: Sep 2019
Location: Portland
Posts: 1,115
Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
Quoted: 451 Post(s)
Liked 364 Times
in
227 Posts
I've done this on some of mine that looked more fragile than others. I have never understood why they so often put what appear to be such cheapo zippers on such expensive jerseys.
#3
Senior Member
Join Date: Mar 2013
Location: Tucson Az
Posts: 1,685
Bikes: 2015 Ridley Fenix, 1983 Team Fuji, 2019 Marin Nail Trail 6
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 343 Post(s)
Liked 236 Times
in
141 Posts
For some reason I've never unzipped my jerseys all the way down, even in the full heat of an Az summer. I've always treated all of them like a half zip jersey, full zip or not.
#4
Full Member
I don't undo zippers all the way on the road like a European pro on an extended hill climb, because no one would want to see that, but I do like undoing them before showering because I don't have to worry about tearing stitching like I do with a damp half zip jersey.
I like jerseys that have zippers I can operate with one hand--those to me signify better construction in most cases.
I like jerseys that have zippers I can operate with one hand--those to me signify better construction in most cases.
Likes For SClaraPokeman:
#5
Me duelen las nalgas
Join Date: Aug 2015
Location: Texas
Posts: 13,513
Bikes: Centurion Ironman, Trek 5900, Univega Via Carisma, Globe Carmel
Mentioned: 199 Post(s)
Tagged: 0 Thread(s)
Quoted: 4560 Post(s)
Liked 2,803 Times
in
1,801 Posts
I had to switch to full zip jerseys in summer 2018 while recovering from a broken and dislocated shoulder. I was concerned about zipper quality but, so far, so good with decent mid-grade quality jerseys from Pearl Izumi (two short sleeve, two long sleeve), Garneau and Bontrager. Pearl Izumi zippers were a bit better integrated into their aero jerseys, but all of 'em seem good enough.
I already had a couple of entry level Garneau jerseys with 1/3-length zippers and they economized there, but those zippers have been fine for five years now. Ditto a low priced "Koramon" no-name jersey from Amazon. Lower cost zipper but it's been fine for three years of regular use.
Most full length zippers on sports wear have finicky entry/ending points (the bottom stops or retainer boxes) where the slider mates the two halves with teeth. I try to be patient zipping and unzipping to avoid damage there.
The worst zippers are usually on bags -- any sort of carrying bag, from camera to laptop and other gear bags. If a low cost bag seems to use good material and seems sturdy but the cost seems improbable for the apparent quality, check the zippers and stitching. That's where the knockoffs, counterfeits and bargain bags will pinch pennies. The first thing to fail on my otherwise decent weatherproof AGU bag (made in Holland) was the zipper on one of the side pouches. I'm guessing they're trying to compete with Ortleib and pinched pennies on zippers. The main closure for the lid is hinged with bungee strap closures, and those have worked fine for several years. But the side pouches are useless because of the zippers. In contrast a Kirtland Tour Pack handlebar bag I bought in the 1970s was still going strong after 30+ years and served hard duty in a second life as a camera gadget bag and utility bag for my safety testing equipment on the job. Some stitched loops failed after several years but the zippers all held up well.
I already had a couple of entry level Garneau jerseys with 1/3-length zippers and they economized there, but those zippers have been fine for five years now. Ditto a low priced "Koramon" no-name jersey from Amazon. Lower cost zipper but it's been fine for three years of regular use.
Most full length zippers on sports wear have finicky entry/ending points (the bottom stops or retainer boxes) where the slider mates the two halves with teeth. I try to be patient zipping and unzipping to avoid damage there.
The worst zippers are usually on bags -- any sort of carrying bag, from camera to laptop and other gear bags. If a low cost bag seems to use good material and seems sturdy but the cost seems improbable for the apparent quality, check the zippers and stitching. That's where the knockoffs, counterfeits and bargain bags will pinch pennies. The first thing to fail on my otherwise decent weatherproof AGU bag (made in Holland) was the zipper on one of the side pouches. I'm guessing they're trying to compete with Ortleib and pinched pennies on zippers. The main closure for the lid is hinged with bungee strap closures, and those have worked fine for several years. But the side pouches are useless because of the zippers. In contrast a Kirtland Tour Pack handlebar bag I bought in the 1970s was still going strong after 30+ years and served hard duty in a second life as a camera gadget bag and utility bag for my safety testing equipment on the job. Some stitched loops failed after several years but the zippers all held up well.
#6
Senior Member
Join Date: Jun 2018
Location: SW Ohio
Posts: 2,399
Mentioned: 93 Post(s)
Tagged: 0 Thread(s)
Quoted: 1105 Post(s)
Liked 1,825 Times
in
878 Posts
I’ve had the zipper slider break on almost every Jersey that I’ve owned despite following the manufacturers recommended washing instructions. To save from repeatedly repairing the zipper, since my jerseys are full zipper and there is no need to zipper them completely open, I just zipper them halfway open and slip them on and off over my head.
#7
Senior Member
Join Date: Sep 2017
Posts: 7,950
Mentioned: 42 Post(s)
Tagged: 0 Thread(s)
Quoted: 7030 Post(s)
Liked 11,060 Times
in
4,729 Posts
Here is an even better tip: any decent seamstress can replace the zipper on a jersey for about $10 or $15.
Likes For Koyote:
#8
Senior Member
Join Date: Jun 2018
Location: SW Ohio
Posts: 2,399
Mentioned: 93 Post(s)
Tagged: 0 Thread(s)
Quoted: 1105 Post(s)
Liked 1,825 Times
in
878 Posts
Good luck finding that these days. We live in a throw away society. For me, a little thread across the zipper to make sure it doesn't come all the way unzipped is more economical than spending 10-15 bucks for every old jersey I own that has a worn zipper end.
Last edited by nomadmax; 03-12-20 at 06:02 AM.
#9
Senior Member
Join Date: Sep 2017
Posts: 7,950
Mentioned: 42 Post(s)
Tagged: 0 Thread(s)
Quoted: 7030 Post(s)
Liked 11,060 Times
in
4,729 Posts
It's not hard to find. There are two in my little town of 5,000 people. Anyone who does tailoring and alterations can replace a zipper.
#10
Senior Member
Join Date: Jan 2010
Posts: 39,321
Mentioned: 211 Post(s)
Tagged: 1 Thread(s)
Quoted: 18446 Post(s)
Liked 15,672 Times
in
7,368 Posts
One perk of living in the "big city." Not far from my house is a cleaners with a great, old world tailor. When I told him how much Jos. Banks gets for a poor hem job on a pair of pants he was shocked. We also still have things like shoe repair places.
#11
Senior Member
This thread has me scratching my head. I probably have 50 jerseys, from ride jerseys to club jerseys to plain colors and 'fun' jerseys. I've never had a zipper or zipper pull break. Some of them are 30 years old. I throw stuff in the washer on regular and tumble dry on low heat.
Likes For BlazingPedals:
#12
Some Weirdo
Join Date: Dec 2017
Location: Rexburg, ID
Posts: 502
Bikes: '86 Schwinn Prelude, '91 Scott Sawtooth, '73 Raleigh "Grand 3"
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 223 Post(s)
Liked 141 Times
in
92 Posts
I don't use the zipper all that much on my jerseys, just donning and doffing. @nomadmax IIRC there's a tailor on Dayton-Xenia near Grange Hall that replaces zippers.
Likes For Ferrouscious:
#13
Senior Member
Join Date: Sep 2012
Location: Brighton, Michigan
Posts: 663
Bikes: Optima Baron LR, '14 Nishiki Maricopa,'87 Trek 330 Elance, '89 Miyata 1400, '85 Peugeot PGN10, '04 Fuji Ace, '06 Giant Rincon, '95 Giant Allegre, '83 Trek 620, '86 Schwinn High Sierra
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 225 Post(s)
Liked 164 Times
in
108 Posts
Thank you for this. We get scarred enough on a daily basis at work. And trust me, no one wants to see the hair on my chest too, especially since its more gray now than ever.
I have 4 jerseys. And two more I've thrown away. Never had a zipper break, but I also air dry my jerseys.
#14
Senior Member
Join Date: May 2012
Location: Point Reyes Station, California
Posts: 4,530
Bikes: Indeed!
Mentioned: 92 Post(s)
Tagged: 0 Thread(s)
Quoted: 1508 Post(s)
Liked 3,483 Times
in
1,133 Posts
This thread has me scratching my head. I probably have 50 jerseys, from ride jerseys to club jerseys to plain colors and 'fun' jerseys. I've never had a zipper or zipper pull break. Some of them are 30 years old. I throw stuff in the washer on regular and tumble dry on low heat.
I'm not sure I have 46 more jerseys in my cycling budget!
Brent
Likes For obrentharris:
#15
Senior Member
Join Date: Sep 2017
Posts: 7,950
Mentioned: 42 Post(s)
Tagged: 0 Thread(s)
Quoted: 7030 Post(s)
Liked 11,060 Times
in
4,729 Posts
We’ve got two seamstresses and a cobbler in my town of 5000. Someone above referred to a “throwaway society,“ but that sort of thing is an individual choice. It’s not forced on us.
#16
Senior Member
Join Date: May 2010
Location: Bristol, R. I.
Posts: 4,340
Bikes: Specialized Secteur, old Peugeot
Mentioned: 20 Post(s)
Tagged: 0 Thread(s)
Quoted: 663 Post(s)
Liked 496 Times
in
299 Posts
I pretty much like to fend for myself. There is repair place in a nearby town I've had do repair work for me. I pretty much like to fend for myself as much as possible. I don't repair shoes, that often, but I do have my own sewing machine for the odd clothes modifying.
#17
Senior Member
Join Date: Apr 2010
Location: Mountain View, CA USA and Golden, CO USA
Posts: 6,341
Bikes: 97 Litespeed, 50-39-30x13-26 10 cogs, Campagnolo Ultrashift, retroreflective rims on SON28/PowerTap hubs
Mentioned: 9 Post(s)
Tagged: 0 Thread(s)
Quoted: 550 Post(s)
Liked 325 Times
in
226 Posts
The zippers are holding up fine machine washing and air drying, apart from perhaps running one thermal jersey through the dryer when I don't get around to laundry until late Sunday evening.
Last edited by Drew Eckhardt; 03-14-20 at 09:52 AM.
#18
Senior Member
Join Date: Dec 2010
Location: northern Deep South
Posts: 8,921
Bikes: Fuji Touring, Novara Randonee
Mentioned: 36 Post(s)
Tagged: 0 Thread(s)
Quoted: 2609 Post(s)
Liked 1,946 Times
in
1,221 Posts
Buy a couple every year. You won't notice the cost at that rate, but after 20 years, you'll have 45 jerseys (somebody will get you an extra for Christmas, or you'll do a supported ride that comes with one, every few years). They almost never wear out -- I think I've only tossed one that really wore out.