2017 Emonda SL 56cm + Extras - $2250 USD, OBO
#1
Junior Member
Thread Starter
Join Date: Mar 2017
Posts: 16
Bikes: 2005 Litespeed Tuscany, 2020 Ribble CGR Ti
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 7 Post(s)
Liked 0 Times
in
0 Posts
2017 Emonda SL 56cm + Extras - $2250 USD, OBO
SOLD
More pics at this link: https://www.dropbox.com/sh/5rqe8stce...2gbOSlF3a?dl=0
More pics at this link: https://www.dropbox.com/sh/5rqe8stce...2gbOSlF3a?dl=0
- ~10k road miles
- Bontrager Race Lite Aero Drop Handlebars Aluminum 42mm 350g
- Bontrager Microfiber Handlebar Tape
- Bontrager Elite Blendr Stem Aluminum w/ Garmin Low Mount + GoPro Mount 100mm 137g
- Cane Creek 100 Headset
- Ultegra R8000 gruppo
- 11-28 Cassette x 3
- 52-36 Crankset 172.5mm
- Dura Ace PD-9000 SPD-SL Pedals
- Aeolus 3 TLR Wheelset, DT Swiss hubs. New aftermarket decals in packaging and will be included with bike.
- Vittoria Corsa Control 2.0 Tires 25mm. Front tire ~ 500 miles, rear is brand new.
- Duotrap S Speed/Cadence Sensor
- Velocomp PowerPod BLE Power Meter
- Bontrager Race Wheelset + wheel bags. Maybe a few hundred miles on the wheels. Intended to use them for riding on crummy roads/conditions.
- Bontrager R3 Tires. Mounted on Aeolus wheels when purchased. Never used them, look new, been hanging in the garage for a few years.
- Cane Creek 52mm bearing/cup for bottom of headset. Bottom of headset takes a 51mm bearing and Cane Creek did not offer that size with the kit, so the original bearing is still in place.
- Two new sets of SwissStop Black Prince brake pads for carbon fiber wheels
- Various extra Blendr interfaces that came with the package.
- Fat cadence sensor magnet
- Duotrap port cover - cover the port in the frame when removing the Duotrap sensor.
- Frame cable port.
- Two extra Ultegra 11-28 cassettes. One was on a different set of wheels, the other on a trainer.
- Fork steerer is uncut.
- Small crack in finish on top tube. Various scuffs/wear marks on frame in different spots seen up-close.
- The extra frame cable port is to replace the port on the downtube for the front derailleur. The bolt holding it in is stripped (which is easily removed with a screw extractor) but Trek did not include a replacement bolt.
- 16.75 lbs w/ pedals, power meter + cage attached. ~16lbs without. Will be close to 15.5 lbs with carbon stem/handlebars.
- Prefer local pickup. Located near Hartford, CT. Willing to meet within an hour's drive.
Last edited by mavickers; 07-06-20 at 10:46 AM. Reason: sold