What is this piece called and can I get replacements
#1
Senior Member
Thread Starter
Join Date: Jun 2010
Location: ATX
Posts: 637
Bikes: CO-OP ADV 3.1 aka Beeftank (stolen, RIP), State All-Road
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 96 Post(s)
Liked 144 Times
in
75 Posts
What is this piece called and can I get replacements
Don’t ask me how I did this, but see pics:
edit: these are TRP brake levers
edit: these are TRP brake levers
Last edited by walnutz; 10-17-20 at 01:48 PM.
Likes For primov8:
#3
Senior Member
Likes For cpach:
#6
I'm good to go!
Join Date: Jul 2017
Location: Mississippi
Posts: 14,987
Bikes: Tarmac Disc Comp Di2 - 2020
Mentioned: 51 Post(s)
Tagged: 0 Thread(s)
Quoted: 6193 Post(s)
Liked 4,809 Times
in
3,317 Posts
Well you know we want to ask what you did. Otherwise we are just going to think you subscribe to the belief that you must tighten everything until you can't turn the wrench any further, and if that happens you put a cheater on it and give it another turn! <grin>
So?
So?
#7
Senior Member
Thread Starter
Join Date: Jun 2010
Location: ATX
Posts: 637
Bikes: CO-OP ADV 3.1 aka Beeftank (stolen, RIP), State All-Road
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 96 Post(s)
Liked 144 Times
in
75 Posts
I’m not sure what happened between taking them off one handlebar and installing on another.
‘Tis a mystery, but thanks again for the help.
#8
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,084
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4205 Post(s)
Liked 3,864 Times
in
2,312 Posts
Perhaps the second handle bar wasn't of the correct diameter and the lever clamp wasn't designed to tighten onto that diameter? Andy
__________________
AndrewRStewart
AndrewRStewart