Chain falls off when rolling backwards
#1
Senior Member
Thread Starter
Chain falls off when rolling backwards
Is this normal?I have a triple shimano105 and if I back the bike up(not on it necesarily)like getting off an elevator the chain falls off the little front cog up front.Other than that the gears are well functioning and adjusted.Anything I can do about this?
#2
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
Is the chain slack in the "granny" (smallest) chainring? Try having the bike in one of the largest rear cogs when in the granny to keep the chain tighter. A sure cure is a chain watcher that physically keeps the chain from falling off of the smallest chainring. The Third Eye Chain Watcher and N-Gear's Jumpstop both work well and are relatively inexpensive
#3
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,092
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4208 Post(s)
Liked 3,874 Times
in
2,314 Posts
The mentioned devices are meant to retain the chain during shifting when pedaling forward, not back pedaling. The little tabs/blocks reside on the upper half of the chainrings and back pedaling drop off starts at the ring's bottom half. But Dave does make a good point about the cog/ring combo employed when drop off happens. One more reason why riding in cross over combos is to be avoided. Andy
__________________
AndrewRStewart
AndrewRStewart
Likes For wphamilton:
#6
Senior Member
Join Date: Jan 2005
Location: Baltimore, MD
Posts: 5,374
Mentioned: 15 Post(s)
Tagged: 0 Thread(s)
Quoted: 2483 Post(s)
Liked 2,955 Times
in
1,678 Posts
When I shift from drive to reverse in my car while still rolling forward at 10 mph, bad things happen. What's wrong with the car?
Many if not most derailleur-equipped bikes will drop the chain in one or more gear combinations. Derailleur systems operate by changing the angle of approach of the chain at the point where it meets the sprocket or chainring. That's a controlled process pedaling forward and an uncontrolled process pedaling backward (or rolling the bike backward).
Moral: don't pedal backward and don't roll the bike backward---bikes aren't designed for that.
Many if not most derailleur-equipped bikes will drop the chain in one or more gear combinations. Derailleur systems operate by changing the angle of approach of the chain at the point where it meets the sprocket or chainring. That's a controlled process pedaling forward and an uncontrolled process pedaling backward (or rolling the bike backward).
Moral: don't pedal backward and don't roll the bike backward---bikes aren't designed for that.
#7
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
Well, yeah, but all four of my 3x10 road bikes will allow indefinite backwards pedaling and rolling the bikes backwards without the chain dropping so it's not a universal problem. However, they in a middle gear and the chain has no slack. I expect the OP's bike is pretty cross chained when this occurs.
#8
Generally bewildered
Join Date: Aug 2015
Location: Eastern PA, USA
Posts: 3,037
Bikes: 2014 Trek Domane 6.9, 1999 LeMond Zurich, 1978 Schwinn Superior
Mentioned: 20 Post(s)
Tagged: 0 Thread(s)
Quoted: 1152 Post(s)
Liked 341 Times
in
251 Posts
Is rolling backward a common activity for you? To steal an idea from Vaudeville, stop rolling backwards.
But does this happen when you pedal backward? As a diagnostic, this issue may have been useful as it alerted you to poor chainline alignment.
But does this happen when you pedal backward? As a diagnostic, this issue may have been useful as it alerted you to poor chainline alignment.
#9
Senior Member
Join Date: Jan 2005
Location: Baltimore, MD
Posts: 5,374
Mentioned: 15 Post(s)
Tagged: 0 Thread(s)
Quoted: 2483 Post(s)
Liked 2,955 Times
in
1,678 Posts
Agreed. For example, all four of my 3x10 road bikes will allow indefinite backwards pedaling and rolling the bikes backwards without the chain dropping so it's not a universal problem. However, they in a middle gear and the chain has no slack. I expect the OP's bike is pretty cross chained when this occurs.
#10
Senior Member
Join Date: Apr 2011
Location: Alpharetta, GA
Posts: 15,280
Bikes: Nashbar Road
Mentioned: 71 Post(s)
Tagged: 0 Thread(s)
Quoted: 2934 Post(s)
Liked 341 Times
in
228 Posts
Seems like dropping the chains because of cross-chained on the small ring will drop off the outside, between the rings. OP gives me the impression that it's dropped to the inside, which would need a really bad chain-line to happen on the small ring and big cog (ie, not cross-chained).
So I wonder if his DR cage is just out of whack, or the hanger. Bent inwards.
ps, it would be a little silly IMO to insist on picking the bike up every time you want to move it backwards, out of fear of exceeding the design capability.
So I wonder if his DR cage is just out of whack, or the hanger. Bent inwards.
ps, it would be a little silly IMO to insist on picking the bike up every time you want to move it backwards, out of fear of exceeding the design capability.
#11
Banned
Join Date: Apr 2010
Location: Lincoln Ne
Posts: 9,924
Bikes: RANS Stratus TerraTrike Tour II
Mentioned: 46 Post(s)
Tagged: 0 Thread(s)
Quoted: 3352 Post(s)
Liked 1,056 Times
in
635 Posts
Rolling a bike backwards, or back pedaling a chain, and having it come off is a good that something is wrong. It could be your dropout alignment.
#12
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
It wasn't intended too as your statements were correct. I was just making the point that the problem isn't universal and that something in the OP's bike configuration is causing his specific problem. I think most of us expect he is badly cross chained or has a major chainline issue.
#13
Senior Member
Join Date: May 2019
Location: Bloomington, IN
Posts: 2,949
Bikes: Paramount, Faggin, Ochsner, Ciocc, Basso
Mentioned: 117 Post(s)
Tagged: 0 Thread(s)
Quoted: 1303 Post(s)
Liked 1,911 Times
in
1,141 Posts
Maybe I am a bit off topic, but what happens when there is not enough chain wrap up from the rear derailleur to keep the chain in place? If the chain is too slack it may drop off from play in the slack chain. JMHO. MH
#14
Senior Member
Join Date: Jun 2014
Location: Ontario, Canada
Posts: 4,624
Bikes: iele Latina, Miele Suprema, Miele Uno LS, Miele Miele Beta, MMTB, Bianchi Model Unknown, Fiori Venezia, Fiori Napoli, VeloSport Adamas AX
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 1324 Post(s)
Liked 927 Times
in
640 Posts
Something somewhere is sticking and possibly sticking just a bit. I'd check the freehub as well as the chain links and the derailleur pulleys.
Cheers
Cheers
#15
Senior Member
When you roll a bike backwards it will pull the chain with it from the top, your crank will turn and on the bottom there is nothing guiding the chain. If in the big/big combination it will fall off on my bike and likely yours too. Moreover, when in this combination the pull of the rear derailleur will exacerbate the motion of the chain as it takes up the slack caused by the falling chain. In other words, once it starts falling you won't be able to stop it by moving the bike forward.
#16
Senior Member
Thread Starter
For those still interested...An update!!!Despite what some people said about "don't roll backwards" you do many times like backing out of an elevator or store with your bike, and too often I would have to put the chain back on.I went to a number of "professionals" with the problem and none had anything positive to say.After looking at the alignment they doubted that was the problem.Anyway the bike developed a serious gear skipping problem and no adjustment or chain replacement would fix it.I finally insisted my neighborhood mechanic examine the derailleur hangar with the proper tool.It was bent!Alas after straightening the bent derailleur hangar I have perfect shifting and no more chain falling off when rolling backwards or pedaling backwards.Halleluyah!
Likes For trek330:
#17
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
![Thumbs Up](images/smilies/thumb.gif)