Thru axle question
#1
Senior Member
Thread Starter
Thru axle question
I just bought a road bike for my wife with disc brakes and thru axles. https://www.liv-cycling.com/us/avail-advanced-1 2 or 3 times a week I'll be removing the front wheel to transport the bike. Do I need to worry about damaging the threads in the fork or on the thru bolt by removing it this frequently? It's my first time with thru axles so I have no experience with them.
Thanks
Tom
Thanks
Tom
#2
Senior Member
Given the length of the axle and it’s inherent alignment, it’s almost impossible to cross-thread the axle. There are people who transport their bike for every ride.
be sure to keep it greased for ease of removal and reinsertion.
be sure to keep it greased for ease of removal and reinsertion.
Likes For Gary in NJ:
#3
jj
Join Date: Jul 2019
Posts: 331
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 140 Post(s)
Liked 110 Times
in
78 Posts
Bike shop mechanics and manufacturer sales reps will say no.
Invest in brushes to clean out the thru holes and the axle’s threads and some shop rags to wipe off the rest of the axle and keep them cleaned and greased to extend their useable life as much as possible.
Next question to pose to your dealer’s mechanic- how often to clean & regrease? Every time? When it looks dirty to me? When it looks dirty to my grandfather (every time, pretty much)?
Invest in brushes to clean out the thru holes and the axle’s threads and some shop rags to wipe off the rest of the axle and keep them cleaned and greased to extend their useable life as much as possible.
Next question to pose to your dealer’s mechanic- how often to clean & regrease? Every time? When it looks dirty to me? When it looks dirty to my grandfather (every time, pretty much)?
Likes For hsuBM:
#4
Senior Member
Thread Starter
Thanks for the good advice and easing my mind.
Tom
Tom
#5
Senior Member
Join Date: Jul 2007
Posts: 7,569
Mentioned: 54 Post(s)
Tagged: 0 Thread(s)
Quoted: 1851 Post(s)
Liked 678 Times
in
429 Posts
You should be more concerned with the front brake. Be sure to put a brake shim in the caliper each time you remove the wheel in case you accidentally grab the brake lever while the wheel is not installed. I've also noticed that when a bike is forward facing on a roof rack, sometimes the wind resistance can be enough to push the brake lever in some.
#6
Senior Member
Thread Starter
Thanks , the bike shop gave me a shim for the front brake and I've practiced with it a bit. I actually mount the bikes in the back of the van. I have fork mounts attached to a 1X4.
Tom
Tom
Likes For jadocs:
#8
Senior Member
Join Date: Jan 2010
Location: TC, MN
Posts: 39,516
Bikes: R3 Disc, Haanjo
Mentioned: 354 Post(s)
Tagged: 1 Thread(s)
Quoted: 20808 Post(s)
Liked 9,450 Times
in
4,668 Posts
Shimano also has little lever blocks that slide in and prevent gear changes in addition to braking. Not sure if they actually sell them separately, but your LBS might have a bucket of them sitting in the back room.
Likes For WhyFi:
#9
Senior Member
Thread Starter
Thanks WhyFi. I'll check, nice tip.
Tom
Tom