How to tell if a brake rotor/pads are worn beyond a safe limit?
#1
Full Member
Thread Starter
Join Date: Sep 2015
Location: Denver Colorado
Posts: 339
Bikes: 2020 Pivot Vault, 1983 Rossin Record, Garneau R1, Mesamods home built gravel/rain commuter bike, 1995 Barracuda A2V modified with Surley single speed dropouts, 1969 Bottecchia junkyard special fixed gear, Cervelo P4, Mesamods 650b klunker
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 96 Post(s)
Liked 72 Times
in
50 Posts
How to tell if a brake rotor/pads are worn beyond a safe limit?
I saw a post a couple of days ago on a Facebook home mechanics group page talking about brake rotor wear. It was very interesting to me that very few knew about what to look for and how to measure. I made a YouTube video later that day at the shop that I shared on the post, but even though both Shimano and SRAM list the minimum rotor width, it seems like one of the most neglected things I see on a daily basis as this is my day job, but in reality, it's definitely one of the most important things to stay on top of maintenance wise. Anyway, this is the video I posted. I'm interested in what other opinions are on the topic and what do you do to measure said brake components.
Last edited by Le Mechanic; 05-16-23 at 07:52 PM. Reason: Video link not showing up.
#2
Senior Member
Join Date: Sep 2017
Posts: 7,887
Mentioned: 38 Post(s)
Tagged: 0 Thread(s)
Quoted: 6972 Post(s)
Liked 10,968 Times
in
4,692 Posts
This is not complicated.
All manufacturers post minimum thicknesses for rotors -- they're usually stamped right on the rotors. I simply measure them with a cheap caliper (easy to do with the wheel mounted to the bike) and replace when necessary.
Pads get replaced when they are worn down to the point that the metal retaining springs are close to making contact with the rotors. I can eyeball them without removing the wheel.
All manufacturers post minimum thicknesses for rotors -- they're usually stamped right on the rotors. I simply measure them with a cheap caliper (easy to do with the wheel mounted to the bike) and replace when necessary.
Pads get replaced when they are worn down to the point that the metal retaining springs are close to making contact with the rotors. I can eyeball them without removing the wheel.
Likes For Koyote:
#3
Full Member
Thread Starter
Join Date: Sep 2015
Location: Denver Colorado
Posts: 339
Bikes: 2020 Pivot Vault, 1983 Rossin Record, Garneau R1, Mesamods home built gravel/rain commuter bike, 1995 Barracuda A2V modified with Surley single speed dropouts, 1969 Bottecchia junkyard special fixed gear, Cervelo P4, Mesamods 650b klunker
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 96 Post(s)
Liked 72 Times
in
50 Posts
Yeah, I agree 100%. I do the same thing, although I think a micrometer works better for the rotors.