Frame painting and cantilever brakes question
#1
Senior Member
Thread Starter
Join Date: Dec 2011
Location: NE Ohio
Posts: 2,595
Bikes: 1992 Serotta Colorado II,Co-Motion Speedster, Giant Escape Hybrid, 1977 Schwinn Super Le Tour
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 455 Post(s)
Likes: 0
Liked 112 Times
in
85 Posts
Frame painting and cantilever brakes question
So as I inch forward toward finishing my frame I have a question. The brake rings & the posts are stainless steel. Would you leave these "raw/unfinished"?
Thanks!
Thanks!
#2
Randomhead
Join Date: Aug 2008
Location: Happy Valley, Pennsylvania
Posts: 24,395
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Liked 3,696 Times
in
2,517 Posts
it would need some paint feature at the stay. I think most people have them painted
#3
framebuilder
The reason to paint them is because there is no definitive line (like a lug shoreline) where the paint stops and the boss begins. It is very difficult to make the transition look clean and not just an ugly jagged edge. And the bottom of the boss is not a stressed area where paint is likely to chip.
#4
Randomhead
Join Date: Aug 2008
Location: Happy Valley, Pennsylvania
Posts: 24,395
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Liked 3,696 Times
in
2,517 Posts
how do those paragon bosses do with paint on them though? The spring plate fits pretty tightly into the part that attaches to the frame. Or is this a Paul brake setup?
What I was thinking when I said "paint feature" was like where the paint ends on chromed stays. They usually put tape over those transitions because otherwise it doesn't look that great
What I was thinking when I said "paint feature" was like where the paint ends on chromed stays. They usually put tape over those transitions because otherwise it doesn't look that great