PVC pipe for a grind rail???
08-04-06, 08:26 PM
#1
X-Up
Thread Starter
Join Date: Aug 2006
Posts: 16
Bikes: DK 6 Pack 06
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
PVC pipe for a grind rail???
Ok so where i like there is no bmx scene whatso ever. NONE. So when my friend got a bike i was psyched. So i was at his house and he said he was making a rail out of PVC piping. I took a look and thought that it would probobly brake. it was about 1.5 inches width including the hole and about .25-.5 cm for the material itself. I think that it wont work out that will and he'll eat road. Please reply soon so he doesnt need new teeth thanx
08-04-06, 08:37 PM
#2
Long haired freak.
Join Date: Jun 2005
Location: Still stuck in hell.
Posts: 6,281
Bikes: 2011 SE Old Man Flyer.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Wont work, dont tell him.
__________________
"the bus came by and I got on, that's when it all began...there was Cowboy Neal at the wheel of a bus to never-ever land."
"the bus came by and I got on, that's when it all began...there was Cowboy Neal at the wheel of a bus to never-ever land."
08-05-06, 12:16 AM
#4
SPACE FOR RENT
Join Date: Jun 2005
Location: dark side of the moon
Posts: 507
Bikes: 05 kink Cielencki, ody LHD cassete hazard light rear,Ody Vandero front, kink og fork, primo tenderizers,fsa pig headset,ody linear slick cable,FSA nasty boy cranks
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Go down to the second hand store and ask them to sell you some bed frames, cut off the ends and you have angle iron to armor up a grind box with. Super cheap. Make this -> https://rampplans.org/ramps/Bud_Strat...Page1.png.html
