Go Back  Bike Forums > Bike Forums > Road Cycling
Reload this Page >

Cracking saddle

Search
Notices
Road Cycling “It is by riding a bicycle that you learn the contours of a country best, since you have to sweat up the hills and coast down them. Thus you remember them as they actually are, while in a motor car only a high hill impresses you, and you have no such accurate remembrance of country you have driven through as you gain by riding a bicycle.” -- Ernest Hemingway

Cracking saddle

Thread Tools
 
Search this Thread
 
Old 09-16-18, 01:28 PM
  #1  
dvai
Junior Member
Thread Starter
 
Join Date: Dec 2016
Posts: 158
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 106 Post(s)
Likes: 0
Liked 4 Times in 4 Posts
Cracking saddle

So I need your help.

My saddle cracks a lot. I have a Trek Domane with standard seat post (steel clamp with carbon post) and a WTB rocket saddle with titanium rails.

You can reproduce the creaking by holding each edge of the saddle and torquing up and down...

The interesting thing is that the creak can increase or decrease depending on how tight the front and rear screws are set. The issue is that you need to adjust those screws in order to set the ideal saddle angle.

I went to my LBS and they said the creaking seems to be from where the rails is inserted in the saddle. They put some lubricant in the area but didn't helped a lot.

I tried to install another saddle (sella italia also with titanium rails) and something similar happens.
Thoughts?

Is this to be expected?
Is there something wrong with the clamp in the seat post?
Is this common in titanium rails?

The creaking drives me nuts when riding.

Any thoughts?
dvai is offline  
Old 09-16-18, 02:11 PM
  #2  
MagicHour
Senior Member
 
MagicHour's Avatar
 
Join Date: Aug 2013
Location: NYC
Posts: 877
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 85 Post(s)
Liked 12 Times in 10 Posts
You try greasing the seatpost bolts?what about hardware on seatpost clamp? Ie barrel nut if it has one.

You can also try wiping down clamp interface/saddle rails too with some rubbing alcohol. I’ve heard of lightly greasing seatpost/ti rail interface too but IME can lead to slippage but something else to try if all else fails.
MagicHour is offline  
Old 09-16-18, 03:16 PM
  #3  
dvai
Junior Member
Thread Starter
 
Join Date: Dec 2016
Posts: 158
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 106 Post(s)
Likes: 0
Liked 4 Times in 4 Posts
I tried grease.. same issue.

I tried cleaning too. Even though not with alcohol.
dvai is offline  
Old 09-16-18, 10:22 PM
  #4  
NILS14
Senior Member
 
NILS14's Avatar
 
Join Date: Mar 2015
Location: Quebec, Canada
Posts: 84

Bikes: Specialized Secteur Sport 2015, Vitus Zenium VRS 2014

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 17 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Put a lot of grease anywhere metal touches metal.

In my case it was the lower saddle clamp part moving against the seatpost that was the issue. I had cleaned and greased it but I hadn't put enough grease.
NILS14 is offline  
Old 09-17-18, 07:36 AM
  #5  
maartendc
Senior Member
 
maartendc's Avatar
 
Join Date: May 2015
Posts: 901

Bikes: BMC SLC01, Trek Checkpoint ALR5

Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 542 Post(s)
Liked 32 Times in 26 Posts
Originally Posted by dvai
So I need your help.

My saddle cracks a lot. I have a Trek Domane with standard seat post (steel clamp with carbon post) and a WTB rocket saddle with titanium rails.

You can reproduce the creaking by holding each edge of the saddle and torquing up and down...

The interesting thing is that the creak can increase or decrease depending on how tight the front and rear screws are set. The issue is that you need to adjust those screws in order to set the ideal saddle angle.

I went to my LBS and they said the creaking seems to be from where the rails is inserted in the saddle. They put some lubricant in the area but didn't helped a lot.

I tried to install another saddle (sella italia also with titanium rails) and something similar happens.
Thoughts?

Is this to be expected?
Is there something wrong with the clamp in the seat post?
Is this common in titanium rails?

The creaking drives me nuts when riding.

Any thoughts?
For me, the type of creaking you describe is usually from dirt and dust in the seat rail clamp.

Take out the saddle and clean the seat clamp VERY thoroughly. Then apply a bit of WD40 to the area. (don't know about grease, seems messy to me). The reinstall the saddle and see if that worked.

Could also be dirt between the seatpost inside of the seat tube. You can take the seatpost out and clean both thoroughly with a rag. Then apply some fiber grip paste to your CF seatpost.

Good luck!
maartendc is offline  
Old 09-19-18, 02:55 PM
  #6  
nesdog
Senior Member
 
Join Date: Nov 2003
Location: Conejo Valley, CA
Posts: 2,692

Bikes: Domane SLR7 Disc

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 68 Post(s)
Liked 67 Times in 39 Posts
I get this same sound on my Domane, using an SMP saddle. It comes and goes so I've never really done anything about it. Drove me nuts as I was thinking it could be BB or spoke or who knows what! Creaking stopped when I unweighted the saddle. May try some of the fixes listed above.
__________________
[insert clever quote here]
nesdog is offline  
Old 09-20-18, 10:13 AM
  #7  
dvai
Junior Member
Thread Starter
 
Join Date: Dec 2016
Posts: 158
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 106 Post(s)
Likes: 0
Liked 4 Times in 4 Posts
What do you mean with "unweighted the saddle"
dvai is offline  
Old 09-20-18, 10:45 AM
  #8  
fietsbob
Banned
 
Join Date: Jun 2010
Location: NW,Oregon Coast
Posts: 43,598

Bikes: 8

Mentioned: 197 Post(s)
Tagged: 0 Thread(s)
Quoted: 7607 Post(s)
Liked 1,355 Times in 862 Posts
I expect the Ti rail is flexing, get steel rail saddles,
or live with the side effects of your gram cutting.

...
fietsbob is offline  
Old 09-20-18, 10:48 AM
  #9  
fietsbob
Banned
 
Join Date: Jun 2010
Location: NW,Oregon Coast
Posts: 43,598

Bikes: 8

Mentioned: 197 Post(s)
Tagged: 0 Thread(s)
Quoted: 7607 Post(s)
Liked 1,355 Times in 862 Posts
Originally Posted by dvai
What do you mean with "unweighted the saddle"
Getting your butt off of it.
fietsbob is offline  
Old 10-04-18, 05:46 PM
  #10  
dvai
Junior Member
Thread Starter
 
Join Date: Dec 2016
Posts: 158
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 106 Post(s)
Likes: 0
Liked 4 Times in 4 Posts
I tried everything.... complete cleant rais and clamp.... with grease, with carbon grip...
Still creaking.

So I switched to a Fabric carbon saddle (carbon rails) and the noise is gone.

The Fabric Scoop is not as comfortable as the WTB but should do.

So is the creaking issue a known problem with titanium rails?
Maybe my saddle had an issue?
dvai is offline  
Old 10-04-18, 05:51 PM
  #11  
Lazyass
Senior Member
 
Join Date: Jul 2008
Location: Minas Ithil
Posts: 9,173
Mentioned: 66 Post(s)
Tagged: 0 Thread(s)
Quoted: 2432 Post(s)
Liked 638 Times in 395 Posts
Make sure it's not your seatpost creaking inside the seat tube. I've had a couple of them I've had to shorten by an inch or two so they don't stick down so far. If they go down too far they can creak. It does sound like it comes from the saddle.
Lazyass is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
GoldenBoy12
Bicycle Mechanics
24
12-19-17 11:38 AM
Chesterton
Bicycle Mechanics
2
08-19-15 05:04 PM
CanadianBiker32
Bicycle Mechanics
2
07-11-15 10:38 PM
due ruote
Classic & Vintage
5
05-17-13 05:19 PM
shralpster
Bicycle Mechanics
4
05-29-10 12:04 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.