MTB to Road brake lever shim?
#1
Senior Member
Thread Starter
Join Date: Aug 2008
Posts: 2,589
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 239 Post(s)
Likes: 0
Liked 7 Times
in
7 Posts
MTB to Road brake lever shim?
Anyone know where I can find a 22.2 to 23.8 shim -mountain to road bar?
I'm doing an experimental handlbar setup and need to put crosstop/interrupter type brake levers onto a mtn flat bar.
Thanks
The primary brakes, are going to be TT reverse brake levers inserted into bar ends... with the interruptors being located where the brakes normally would be...
I'm doing an experimental handlbar setup and need to put crosstop/interrupter type brake levers onto a mtn flat bar.
Thanks
The primary brakes, are going to be TT reverse brake levers inserted into bar ends... with the interruptors being located where the brakes normally would be...
#2
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
Any 0.8 mm (0.03") shim stock should work. Auto and industrial supply shops carry it in brass, steel or aluminum and you might even find some in a bigger hardware store or home centers. Buy a small sheet and cut strips to fit.