Can I patch these cuts on the tire?
#1
Newbie
Thread Starter
Can I patch these cuts on the tire?
I got these cuts on my front tire last night (Conti grand sport race 23c clincher). There were two cuts, one on the side wall in the middle, exposing the threads, and the longer one on the right. The inner tube was OK, I did not get any flat or leak. However I am worried that these cuts will cause a blowout later. Is there any preventive measure I can do (other than replacing the tire). Thx
#2
Senior Member
Join Date: Jul 2015
Location: reno, nv
Posts: 2,298
Bikes: yes, i have one
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 1136 Post(s)
Liked 1,179 Times
in
686 Posts
the tires are really quite filthy and so i cannot really see any cuts. a cut on the sidewall is probably not worth your skin fixing. a blowout at high speed (turning) would not be pleasant.
my two cents.
my two cents.
#5
Junior Member
If you can see the threads, toss it. The risk of a blowout and subsequent damage isn’t worth the low cost of a bicycle tire....
Likes For BHG6:
#6
Senior Member
Join Date: Jun 2018
Location: SW Ohio
Posts: 2,397
Mentioned: 93 Post(s)
Tagged: 0 Thread(s)
Quoted: 1104 Post(s)
Liked 1,824 Times
in
878 Posts
Booting a tire with sidewall cuts to avoid a long walk in cycling shoes? Sure. Doing that when you're home and a new tire is available? Naw.
Likes For nomadmax:
#7
Really Old Senior Member
Apparently you like gazing at stars? Then leave it on.
Likes For Bill Kapaun:
#9
Senior Member
Join Date: Jan 2013
Posts: 2,674
Bikes: too many sparkly Italians, some sweet Americans and a couple interesting Japanese
Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
Quoted: 567 Post(s)
Liked 563 Times
in
405 Posts
I have run tires down to the threads from wear, not side wall damage, but I ride on 5-8' bike lanes that are routinely swept clean and maintained. I would not be comfortable on a high speed decline with a tight corner or rough road at the bottom with a damaged tire.