How long typically do bike tires hold enough air?
#1
Junior Member
Thread Starter
How long typically do bike tires hold enough air?
I have BMX 20" x 2.xx tubes/tires.
They are pumped up a little every five days or so, to almost 60 psi.
I suppose maybe lower versus higher pressure makes some difference?
Does Schrader versus Presta valves make any difference?
I just want a general idea.
Thanks.
They are pumped up a little every five days or so, to almost 60 psi.
I suppose maybe lower versus higher pressure makes some difference?
Does Schrader versus Presta valves make any difference?
I just want a general idea.
Thanks.
#2
Junior Member
Join Date: Nov 2019
Posts: 16
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 5 Post(s)
Likes: 0
Liked 4 Times
in
3 Posts
Fat low pressure tires require more air every three or four days. Roadie high pressure tires require more air almost every day. The valve type doesn't matter.
Last edited by duckhuntr; 03-01-20 at 09:13 PM.
#3
Tragically Ignorant
Join Date: Jun 2018
Location: New England
Posts: 15,613
Bikes: Serotta Atlanta; 1994 Specialized Allez Pro; Giant OCR A1; SOMA Double Cross Disc; 2022 Allez Elite mit der SRAM
Mentioned: 62 Post(s)
Tagged: 0 Thread(s)
Quoted: 8186 Post(s)
Liked 9,098 Times
in
5,054 Posts
Low pressure tires like you've got lose air more slowly than high pressure for the simple reason that air under pressure diffuses through the pores in the tires faster.
You mention it's a BMX--are you doing any jumps on it or anything where the tire pressure might be more critical than normal riding?
You mention it's a BMX--are you doing any jumps on it or anything where the tire pressure might be more critical than normal riding?
#4
Senior Member
Join Date: Feb 2017
Location: Hollister, CA (not the surf town)
Posts: 1,737
Bikes: 2019 Specialized Roubaix Comp Di2, 2009 Roubaix, early 90's Giant Iguana
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 643 Post(s)
Liked 1,526 Times
in
551 Posts
If you're putting 60psi in a 2 inch tire, you could probably go months and not need to refill. It'll drop a fair amount at first and then lose air very slowly. I run 40 and 35 in 1.75" tires and can go 4 weeks easily without pumping them up. They lose about 5-7PSI in that time.
#5
Senior Member
My rule of thumb for all tire sizes: one week.
Likes For ramzilla:
Likes For Gconan:
#7
Junior Member
Like other maintenance issues there really is no typical. Depends on your inner tubes and how demanding you are of your bike. Best practice is to check the pressure prior to every outing. Or at least every day if you use your bike for multiple short rides during the day. As you experiment with tire pressure you will probably discover that your bike will perform best with different pressures for various riding conditions. Good luck!
#8
Senior Member
My bike shop owner pal once explained to me why certain of their customers came in every 3 months for new tubes. It was because that was how long it took for the tire pressure to drop to the point where the tires suffered pinch flats, which required both tubes to be replaced.
My pal once got bold enough to ask one such repeat customer why they didn't just buy a pump and regularly inflate their tires. The incredulous response by the customer was they could just come in to the shop to get the tubes replaced, and tires re-inflated. It's a living, I guess.
If someone ever thinks that working in a bike shop is an adventure filled with working on cutting-edge tech and servicing high-performance customers.... well it isn't. Most of the work is tedious repetitive stupid crap like this.
I've also wondered why I regularly find 30-year old bikes in garage sales which were only ridden 3-months from shop floor to hanging in the rafters. Same reason: tires became deflated, then pinch flats, and owners used this as the excuse to finish with the bike phase thing once and forever.
My pal once got bold enough to ask one such repeat customer why they didn't just buy a pump and regularly inflate their tires. The incredulous response by the customer was they could just come in to the shop to get the tubes replaced, and tires re-inflated. It's a living, I guess.
If someone ever thinks that working in a bike shop is an adventure filled with working on cutting-edge tech and servicing high-performance customers.... well it isn't. Most of the work is tedious repetitive stupid crap like this.
I've also wondered why I regularly find 30-year old bikes in garage sales which were only ridden 3-months from shop floor to hanging in the rafters. Same reason: tires became deflated, then pinch flats, and owners used this as the excuse to finish with the bike phase thing once and forever.
Likes For Dave Mayer:
#9
Senior Member
A week, under normal riding conditions. With the BMX, you'll probably want lower pressure for riding in the sand, and higher for hard dirt/paved roads. In that case, replacing air is required before every ride. If you can judge air pressure by touch, that makes a quick pre-ride check easy, but you should always check PSI before every ride... assuming your tires are rated 40 - 60 PSI, in a week you'll probably only drop from 60 to 50+/-, and that is a good point to top off. Otherwise, they'll stay in the safe zone for weeks with harder pedal power required and smoother shock absorption. That is a judgement call for the rider, but either way, check PSI before every ride, and every now and again a slow overnight leak will be found.
#10
Senior Member
Yeah, the only thing "typical" about air loss is that it'll happen. In my experience, high-pressure latex tubes can lose 20 psi over the course of a single ride. Lightweight butyl tubes will lose air more slowly, and heavy butyl touring tubes even more slowly. Also, heavier tires seem to help hold air longer. My road bikes need more air about every other day.
#12
Senior Member
Join Date: Jan 2009
Location: Colorado Springs, CO
Posts: 5,974
Bikes: 2015 Charge Plug, 2007 Dahon Boardwalk, 1997 Nishiki Blazer, 1984 Nishiki International, 2006 Felt F65, 1989 Dahon Getaway V
Mentioned: 54 Post(s)
Tagged: 0 Thread(s)
Quoted: 1364 Post(s)
Liked 1,677 Times
in
827 Posts
As has been discussed before, In cold weather tires tend to hold inflation longer. In hot weather they seem to loose pressure faster. At least that's been my experience.
I bike commute most days, but my fenderless 700x28 12-speed may sit for a month untouched in the winter. I usually run the tires at 90psi, and aftersitting for a month they may be as low as 65psi., but sometimes only down to 80 after a month.
I bike commute most days, but my fenderless 700x28 12-speed may sit for a month untouched in the winter. I usually run the tires at 90psi, and aftersitting for a month they may be as low as 65psi., but sometimes only down to 80 after a month.
#13
working on my sandal tan
Join Date: Aug 2011
Location: CID
Posts: 22,629
Bikes: 1991 Bianchi Eros, 1964 Armstrong, 1988 Diamondback Ascent, 1988 Bianchi Premio, 1987 Bianchi Sport SX, 1980s Raleigh mixte (hers), All-City Space Horse (hers)
Mentioned: 98 Post(s)
Tagged: 0 Thread(s)
Quoted: 3871 Post(s)
Liked 2,568 Times
in
1,579 Posts
+1. I pinch my tires before every ride. It's not a very precise check, but it's enough to alert me if the tires are squishier enough than usual to warrant pumping (and the pump has a gauge.)
Likes For ThermionicScott:
#14
Gone Biking!
Join Date: Dec 2009
Location: Indiana
Posts: 150
Bikes: Orbea Gain, Lynskey, Redline Conquest Disc, Bike Friday, Cannnondale T2 Tandem.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 42 Post(s)
Liked 50 Times
in
28 Posts
+1 I have followed this rule of thumb 7 days per tire for over 220,000 miles. Do the tires lose some air over 7 days, yes, does it negatively affect their performance, not in my experience. Road bike tires, 85 psi rear and 70 psi front. Has served me well. IMOP people get too anal over their tire pessure.
Likes For Pridedog:
#15
Disco Infiltrator
Join Date: May 2013
Location: Folsom CA
Posts: 13,446
Bikes: Stormchaser, Paramount, Tilt, Samba tandem
Mentioned: 72 Post(s)
Tagged: 0 Thread(s)
Quoted: 3126 Post(s)
Liked 2,105 Times
in
1,369 Posts
When it goes from feeling like an orange to feeling like a banana
__________________
Genesis 49:16-17
Genesis 49:16-17
#16
Banned
Join Date: Feb 2008
Location: Mississauga/Toronto, Ontario canada
Posts: 8,721
Bikes: I have 3 singlespeed/fixed gear bikes
Mentioned: 30 Post(s)
Tagged: 0 Thread(s)
Quoted: 4227 Post(s)
Liked 2,488 Times
in
1,286 Posts
I usually pump my tires up once every 2-3 weeks.
#17
Junior Member
Thread Starter
That's what I wanted to know, so I can better tell when there might be a problem (like when using substandard parts).
Thanks to the replies.
Thanks to the replies.
#18
Senior Member
I suspect that if you do the pinch check regularly it might be as good or better a method than a cheapish gauge. I know how my tire must feel when pinched for it to have the optimum ride, but I've forgotten what pressure reading that corresponds to, since it's been a while I used a pump with a gauge.
#19
Senior Member
Join Date: Jan 2016
Posts: 3,449
Mentioned: 33 Post(s)
Tagged: 0 Thread(s)
Quoted: 874 Post(s)
Liked 2,288 Times
in
1,278 Posts
On my vintage racers I check the tire pressure every week when I ride. I have several bikes in rotation and it may be 2-3 weeks since the last time I rode a certain bike. If I ride on particular bike more often I still check the pressure and give it a pump. Joe. Joesvintageroadbikes.wordpress
#20
Senior Member
Join Date: Jul 2008
Location: 25 miles northwest of Boston
Posts: 29,549
Bikes: Bottecchia Sprint, GT Timberline 29r, Marin Muirwoods 29er, Trek FX Alpha 7.0
Mentioned: 112 Post(s)
Tagged: 0 Thread(s)
Quoted: 5224 Post(s)
Liked 3,581 Times
in
2,342 Posts
related: aren't some tube materials better at holding air?
latex tubes leak air more quickly than a butyl tube. but most tubes are butyl I think
latex tubes leak air more quickly than a butyl tube. but most tubes are butyl I think
#21
Senior Member
Join Date: Oct 2018
Location: VA
Posts: 1,437
Bikes: SuperSix Evo | Revolt
Mentioned: 12 Post(s)
Tagged: 0 Thread(s)
Quoted: 733 Post(s)
Liked 815 Times
in
414 Posts
As always, it depends. I run tubeless on the gravel bike and latex tubes on the road bike, both require checking/pumping every ride. It's just become part of my routine.