Brooks Champion Flyer missing something?
#1
Newbie
Thread Starter
Join Date: Oct 2013
Posts: 63
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 12 Post(s)
Liked 0 Times
in
0 Posts
Brooks Champion Flyer missing something?
I was hoping someone familiar with brooks saddles could shed some light on this. I recently purchased used a Brooks Champion Flyer on Ebay. I threw out an offer to the seller and they excepted. I really didn't scrutinize the photos closely, and I'm not familiar with the way these look underneath, but when I looked back at the photos later, I noticed that the underside of this saddle looks different than brooks photos I am pulling off the web. For one thing, it has only one pair of rails which seems unusual. The other thing I am puzzled by is the tightening pin area. I see no bolt or pin there. Is something missing? If so, is this a part that I can find easily for sale?
Here is a picture. Any help is appreciated.
Here is a picture. Any help is appreciated.
#3
Newbie
Definitely looks like the tensioning bolt is either missing or it has been replaced. I would agree on your rail assessment as well. You can see marks in the leather where it may have rubbed on them.
#5
Senior Member
Join Date: Feb 2008
Location: Peoria, IL
Posts: 4,478
Mentioned: 86 Post(s)
Tagged: 0 Thread(s)
Quoted: 1829 Post(s)
Liked 3,377 Times
in
1,581 Posts
There's a lot of non-original hardware in that photo!
This is what one of my Champion Flyers looks like...
Steve in Peoria
This is what one of my Champion Flyers looks like...
Steve in Peoria
Likes For steelbikeguy:
#6
multimodal commuter
Join Date: Nov 2006
Location: NJ, NYC, LI
Posts: 19,808
Bikes: 1940s Fothergill, 1959 Allegro Special, 1963? Claud Butler Olympic Sprint, Lambert 'Clubman', 1974 Fuji "the Ace", 1976 Holdsworth 650b conversion rando bike, 1983 Trek 720 tourer, 1984 Counterpoint Opus II, 1993 Basso Gap, 2010 Downtube 8h, and...
Mentioned: 584 Post(s)
Tagged: 0 Thread(s)
Quoted: 1908 Post(s)
Liked 574 Times
in
339 Posts
Yeah, the tension bolt is all wrong, and one of the V-shaped pieces of the frame is missing. There is no way to put tension on the leather, so I'm afraid this saddle will not be ridable.
__________________
www.rhmsaddles.com.
www.rhmsaddles.com.
Likes For rhm:
#7
Newbie
Thread Starter
Join Date: Oct 2013
Posts: 63
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 12 Post(s)
Liked 0 Times
in
0 Posts
Bummer. Well it was listed as used but "fully functional", so I suppose I will ask for a return. If they refuse I will have to open a not as described case I suppose.
Now that I understand the design better of the sprung model frames, I can see the lower bracket is missing, and parts of the tensioning mechanism.
Now that I understand the design better of the sprung model frames, I can see the lower bracket is missing, and parts of the tensioning mechanism.