Go Back  Bike Forums > Bike Forums > Triathlon
Reload this Page >

Do I Need Shorter Cranks?

Triathlon Swim / Bike / Run your thing? Drop in our new triathlon forum for the latest in training & gear. From beginner to expert, and sprint to ironman.

Do I Need Shorter Cranks?

Old 09-08-19, 02:34 PM
  #1  
tsappenfield
Senior Member
Thread Starter
 
Join Date: Oct 2008
Location: Akron, OH
Posts: 424

Bikes: 2008 Seven Axiom Steel, 1984 Colnago Nuovo Mexico, 2008 Cervelo P2C, 2000 Trek Multitrack 7200

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 17 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Do I Need Shorter Cranks?

My bike is a Cervelo P2C with 175 mm cranks. I'm 5' 10" with an inseam of 30.5". I'm a very good Senior Games time trial racer having won several medals at the local and state levels for the past several years. When I race, I'm riding on the nose of my saddle. I'm also soon to be 77 years old. All of the above is to set up my problem. As my knees (either one) approach the 12:00 position, they begin to significantly flare out so that my lower body becomes sort of parachute-like. NOT GOOD! This doesn't happen "much" when I'm on my road bike. I absolutely can not raise my seat post and saddle any higher on the time trial bike. So I'm thinking maybe 170 mm cranks might help solve the problem or should I just start racing using my road bike?
Tsapp
tsappenfield is offline  
Old 09-09-19, 10:49 AM
  #2  
burnthesheep
Newbie racer
 
Join Date: Feb 2018
Location: Raleigh, NC
Posts: 1,050

Bikes: Propel, red is faster

Mentioned: 28 Post(s)
Tagged: 0 Thread(s)
Quoted: 475 Post(s)
Liked 125 Times in 81 Posts
I'm about that height, it is essentially a super easy gain in terms of hip flexion or whatever you call it. Either more aero at same hip angle, or more power at a better angle.

I had 175's and went to 165's. It's a legitimate and accepted change to make.

IMO if budget on selling/buying your cranks to swap is good, go for it. Also, if you have more money to spend, a really low stack pedal setup like Speedplay Zeros can get another mm or few over SPD-SL's.
burnthesheep is offline  
Old 09-10-19, 06:32 AM
  #3  
berner
Senior Member
 
Join Date: May 2010
Location: Bristol, R. I.
Posts: 3,530

Bikes: Specialized Secteur, old Peugeot

Mentioned: 14 Post(s)
Tagged: 0 Thread(s)
Quoted: 328 Post(s)
Liked 59 Times in 48 Posts
My inseam is 30.75" and cranks are 170mm. I have found that during winter backpacking wearing heavy insulated boots and snowshoes. the muscles that raise the legs can tire. I used to do leg exercises for this with 10 pound leg weights. Those same muscles raise the legs during cycling. On long rides, when I begin to tire, I've noticed that the leg at the bottom of the pedal stroke begins to relax and becomes dependent on the down stroke to raise it. Consequently, I guess that a shorter crank would save the legs just a bit so they would not need to flare out at the top of the pedal stroke.
berner is offline  
Old 09-11-19, 04:59 AM
  #4  
rubiksoval
Senior Member
 
Join Date: Nov 2015
Location: Music City, USA
Posts: 2,938

Bikes: Felt AR

Mentioned: 48 Post(s)
Tagged: 0 Thread(s)
Quoted: 1707 Post(s)
Liked 83 Times in 50 Posts
I'm 5'11 and run 165 on road and tt bikes.
rubiksoval is offline  
Old 09-11-19, 08:53 AM
  #5  
_ForceD_
Senior Member
 
_ForceD_'s Avatar
 
Join Date: Jul 2015
Location: Rhode Island
Posts: 1,054

Bikes: Several...from old junk to new all-carbon.

Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 418 Post(s)
Liked 22 Times in 16 Posts
Originally Posted by tsappenfield View Post
So I'm thinking maybe 170 mm cranks might help solve the problem or should I just start racing using my road bike?

I'm not an expert on bike fit by any means. But, I just want to point out a couple of observations. The 5mm difference between 175mm and 170mm is less than a quarter of an inch (0.197 inch). Do you think that will give you the desired affect you're looking for on the TT bike? Also, I'm wondering if your "knees flaring out" on the TT bike as opposed to on your road bike might be the result of being down on the aero bars and your body thereby being more 'scrunched up.' As such...the problem might not be caused by crank length or seat height, but by the height of your aero bars...and maybe the distance between the seat and the aero bars. You might consider altering the length and/or height of the stem, and/or the fore-aft position of the seat. I was wondering about obtaining a longer seatpost. But it looks like that Cervelo you have has a pretty specific aero post that might not be available in longer lengths.
Dan

Last edited by _ForceD_; 09-11-19 at 09:01 AM.
_ForceD_ is offline  
Old 09-13-19, 09:44 AM
  #6  
trailangel
Senior Member
 
trailangel's Avatar
 
Join Date: Feb 2014
Location: Pasadena, CA
Posts: 3,790

Bikes: Schwinn Varsity

Mentioned: 17 Post(s)
Tagged: 0 Thread(s)
Quoted: 1361 Post(s)
Liked 95 Times in 63 Posts
The difference is 10mm, almost half an inch.
trailangel is offline  
Old 09-13-19, 12:58 PM
  #7  
burnthesheep
Newbie racer
 
Join Date: Feb 2018
Location: Raleigh, NC
Posts: 1,050

Bikes: Propel, red is faster

Mentioned: 28 Post(s)
Tagged: 0 Thread(s)
Quoted: 475 Post(s)
Liked 125 Times in 81 Posts
Originally Posted by trailangel View Post
The difference is 10mm, almost half an inch.
I went 175 to 165. It's actually the difference, times two. The way I see it.

You gain 10mm in aero by raising the saddle for the 10mm less at BDC. Then you gain 10mm towards hip angle at TDC.

I may be wrong on that, but feels that way to me!

This is also why a low stack pedal like a Speedplay Zero Aero matters. Even 1mm there you can essentially double.
burnthesheep is offline  
Old 09-13-19, 02:30 PM
  #8  
trailangel
Senior Member
 
trailangel's Avatar
 
Join Date: Feb 2014
Location: Pasadena, CA
Posts: 3,790

Bikes: Schwinn Varsity

Mentioned: 17 Post(s)
Tagged: 0 Thread(s)
Quoted: 1361 Post(s)
Liked 95 Times in 63 Posts
Uh, that's what I just said.
trailangel is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.