recommend me a fork
#1
Senior Member
Thread Starter
recommend me a fork
Seems like it's a bit hard to find a fork's specs, most online shop only state the steerer length. I'm in the process of ordering a custom Ti frame, but they don't stock any fork. As the builder let the customer submit their own frame measurements I guess I need to find a fork first, so I can determine the HT angle/length based on the crown-to-axle length and the rake size
Any recommendation of a good carbon (or steel?) fork around $250 with clearance for 28c tyre with short reach brake.
Any recommendation of a good carbon (or steel?) fork around $250 with clearance for 28c tyre with short reach brake.
#2
Should Be More Popular
Join Date: Dec 2007
Location: Malvern, PA (20 miles West of Philly)
Posts: 43,044
Bikes: 1986 Alpine (steel road bike), 2009 Ti Habenero, 2013 Specialized Roubaix
Mentioned: 560 Post(s)
Tagged: 2 Thread(s)
Quoted: 22590 Post(s)
Liked 8,924 Times
in
4,157 Posts
#4
.
Join Date: Apr 2015
Location: Portland Oregon USA
Posts: 240
Bikes: 04 Giant TCR Composite 0, Public r16; old Raleigh 10sp; Felt fixie
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
You're building a custom Ti bike and want to keep it cheap?
#5
Senior Member
Thread Starter
#6
Senior Member
Join Date: Dec 2009
Location: Houston, TX
Posts: 28,682
Bikes: 1990 Romic Reynolds 531 custom build, Merlin Works CR Ti custom build, super light Workswell 066 custom build
Mentioned: 109 Post(s)
Tagged: 1 Thread(s)
Quoted: 6556 Post(s)
Likes: 0
Liked 58 Times
in
36 Posts
OP, you would want to be very careful buying a "used" fork off ebay, but that can be a very cost-effective way to go about it. There are lots of forks floating around the lightly used market due to them being cut too short by mistake. Many have never been ridden, just made too small for the original owners in the cutting process. Their loss can be your gain. Just do your best to verify that the fork was never crashed or damaged any other way. There are usually lots of Ritcheys to be had that way. Also be sure the steerer matches your frame in terms of dimensions, taper, etc.
Last edited by rpenmanparker; 03-03-16 at 08:32 AM.
#12
Senior Member
#13
Senior Member
Thread Starter
OP, you would want to be very careful buying a "used" fork off ebay, but that can be a very cost-effective way to go about it. There are lots of forks floating around the lightly used market due to them being cut too short by mistake. Many have never been ridden, just made too small for the original owners in the cutting process. Their loss can be your gain. Just do your best to verify that the fork was never crashed or damaged any other way. There are usually lots of Ritcheys to be had that way. Also be sure the steerer matches your frame in terms of dimensions, taper, etc.