reccomendation on a set of rollers
#1
Senior Member
Thread Starter
reccomendation on a set of rollers
Anyone have a set they would like to comment on?
__________________
I have NEVER regretted going on a ride;
I have often regretted not going when I could have!
I am grateful for the headwind that challenged me today!
I am grateful for the tailwind that helped me go fast!
Clydesdales and Athenas Strava Club
https://www.strava.com/clubs/clydesda...bikeforums-net
I have NEVER regretted going on a ride;
I have often regretted not going when I could have!
I am grateful for the headwind that challenged me today!
I am grateful for the tailwind that helped me go fast!
Clydesdales and Athenas Strava Club
https://www.strava.com/clubs/clydesda...bikeforums-net
#2
Senior Member
Join Date: Jan 2010
Posts: 39,221
Mentioned: 211 Post(s)
Tagged: 1 Thread(s)
Quoted: 18404 Post(s)
Liked 15,496 Times
in
7,318 Posts
I had Kreitlers once. The large drum kind. Could never get used to rollers no matter how hard I tried so I sold them to a guy who bikes a lot. He could never get used to rollers no matter how hard he tried so I sold them to someone else who bikes a lot. Don't know what happened to them after that.
You might consider a trainer as well. No learning curve. Rollers had a huge learning curb for me. I even rode off into a wall a couple of times.
You might consider a trainer as well. No learning curve. Rollers had a huge learning curb for me. I even rode off into a wall a couple of times.
#3
Senior Member
+1 on the trainer
I use a CycleOps Fluid2 trainer. I do use a different wheel on the trainer because I'm not sure about how much a trainer will wear a tire. Got the rear wheel inexpensively, and since the trainer requires its own skewer, it made since to just use a different wheel. Get a couple of blocks for the front wheel too. It will simulate climbing a low-grade hill.
I use a CycleOps Fluid2 trainer. I do use a different wheel on the trainer because I'm not sure about how much a trainer will wear a tire. Got the rear wheel inexpensively, and since the trainer requires its own skewer, it made since to just use a different wheel. Get a couple of blocks for the front wheel too. It will simulate climbing a low-grade hill.
#4
Ancient Clydesdale
I have a set of Kreitler rollers. I had no problems learning how to ride them, to me it seems very logical and natural. If you aren't put off by the minor challenge of learning a new skill, rollers might be a good idea for you.
Kreitler's are the "Cadillac" of static rollers. The e-motion type are much more expensive and most are well made. I modified my Kreitler rollers to the e-motion configuration and they work great.
I've ridden trainers, but IMO they induce unnatural stresses on the bicycle frame and are BORING.
Kreitler's are the "Cadillac" of static rollers. The e-motion type are much more expensive and most are well made. I modified my Kreitler rollers to the e-motion configuration and they work great.
I've ridden trainers, but IMO they induce unnatural stresses on the bicycle frame and are BORING.
#5
Senior Member
Join Date: Jan 2010
Posts: 39,221
Mentioned: 211 Post(s)
Tagged: 1 Thread(s)
Quoted: 18404 Post(s)
Liked 15,496 Times
in
7,318 Posts
#6
Senior Member
Join Date: Jan 2012
Location: Toronto , Ontario , Canada
Posts: 542
Bikes: Colnago EP with Campy chorus
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 23 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
What 2 wheeler tried to say is you need to concentrate while on the roller or you will fall off the bike . Is not like a trainer when you can hop on the bike and pedal mindlessly for hours .
#7
Commuter & cyclotourist
Join Date: Feb 2009
Location: Hadley, MA, USA
Posts: 496
Bikes: Boulder All Road, Surly Long Haul Trucker, Bike Friday New World Tourist, Breezer Uptown 8, Bike Friday Express Tikit, Trek MultiTrack 730 (Problem? No, I don't have a problem)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I love my TruTrainer rollers. The drums are large, like Kreitlers, but one of them has a concentric flywheel that spins at a different rate than the shell. The result is variable resistance that increases with speed, mimicking the effects of cycling against the wind. If you get them, I recommend the flywheel quick release option, which lets you use them like classic rollers (no resistance) for work on form.
One nice thing about the TruTrainer rollers is that the flywheel keeps the rear wheel spinning when you stop pedaling; you gradually slow down, just as if you were coasting to a stop on the road. That makes it easier to learn to ride them.
I have no connection to the company other than as a satisfied customer.
One nice thing about the TruTrainer rollers is that the flywheel keeps the rear wheel spinning when you stop pedaling; you gradually slow down, just as if you were coasting to a stop on the road. That makes it easier to learn to ride them.
I have no connection to the company other than as a satisfied customer.
__________________
--
Brian Ogilvie, Hadley, MA, USA
--
Brian Ogilvie, Hadley, MA, USA
#8
Senior Member
I have the Cycleops rollers. From my research when I got those, it was metal rollers over plastic (plastic can deform, especially if left in the sun or a hot car) and the larger the roller wheels, the less resistance they offer. This is of course negated if you go for something like the TruTrainers.
My training is track orientated and so with lots of standing starts and sprinting type training, I make more use of a trainer rather than the rollers.
My training is track orientated and so with lots of standing starts and sprinting type training, I make more use of a trainer rather than the rollers.
#9
Senior Member
Join Date: Sep 2006
Location: Paradise, TX
Posts: 2,087
Bikes: Soma Pescadero, Surly Pugsley, Salsa Fargo, Schwinn Klunker, Gravity SS 27.5, Monocog 29er
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 186 Post(s)
Liked 234 Times
in
166 Posts
Skip the rollers and just get some wool gear.
#10
Ancient Clydesdale
Says the guy from TEXAS.
Bring your wool gear up here to the east side of the Cascade Mountains when the roads are icy and it's in the teens. Dare ya!!
(North Texas gets cold, do you really ride in the worst Paradise, TX weather????)
Bring your wool gear up here to the east side of the Cascade Mountains when the roads are icy and it's in the teens. Dare ya!!
(North Texas gets cold, do you really ride in the worst Paradise, TX weather????)
#11
Senior Member
Join Date: Jan 2013
Location: PNW - USA
Posts: 265
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
What are the temps right now in Texas? Mid-70's? We call that high-summer in these parts.
#12
Senior Member
Join Date: Sep 2006
Location: Paradise, TX
Posts: 2,087
Bikes: Soma Pescadero, Surly Pugsley, Salsa Fargo, Schwinn Klunker, Gravity SS 27.5, Monocog 29er
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 186 Post(s)
Liked 234 Times
in
166 Posts
I do know cold, I grew up in northeast Ohio and lived north of Chicago for a few years. The original poster says he's from South Carolina. Shouldn't be a problem.
#13
Grouch
Join Date: May 2010
Location: Bucks County, PA
Posts: 88
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 5 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
+100 for Rollers
I purchased mine from Performance bikes. I purchased the cheapest model they offered and have been very happy. I ride mine for anywhere for a half to two hours while watching bike videos or a movie. While there may be a learning curve, I found it not as dramatic as some might suggest. You need to look straight ahead and not down at the front wheel in the beginning. Start by riding them in a doorway or a narrow hallway so that you can catch yourself should you initially falter. Keep trying, you will get the hang of it.
I too have a fluid trainer but find it quite boring compared to my rollers. My wife prefers the trainer. On the rollers, you must ride your bike as opposed to spinning away, If you think you can balance on a bike now, wait till you come back outside after riding rollers for a winter. I can now ride ON the white line on the side of the road for a mile plus. Your balance will greatly improve.
Here is a Beginner
This chap may have been at it awhile
I purchased mine from Performance bikes. I purchased the cheapest model they offered and have been very happy. I ride mine for anywhere for a half to two hours while watching bike videos or a movie. While there may be a learning curve, I found it not as dramatic as some might suggest. You need to look straight ahead and not down at the front wheel in the beginning. Start by riding them in a doorway or a narrow hallway so that you can catch yourself should you initially falter. Keep trying, you will get the hang of it.
I too have a fluid trainer but find it quite boring compared to my rollers. My wife prefers the trainer. On the rollers, you must ride your bike as opposed to spinning away, If you think you can balance on a bike now, wait till you come back outside after riding rollers for a winter. I can now ride ON the white line on the side of the road for a mile plus. Your balance will greatly improve.
Here is a Beginner
This chap may have been at it awhile
#14
Senior Member
Join Date: Jul 2009
Location: Central Coast, California
Posts: 3,370
Bikes: Colnago C-50, Calfee Dragonfly Tandem, Specialized Allez Pro, Peugeot Competition Light
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Rollers are great. I'd recommend mine but I haven't seen them on the market for a while (mine look like the ones in Deavers' second video). They are large drum. I'm not sure how much difference large vs small drum makes as far as resistance goes. I think tire pressure is a far bigger factor. Lower the are pressure in your tires and it's get real hard in a hurry. There is a minor learning curve but once you get used to them they're no big deal. I can ride on them with no hands or on my aerobars with no problem now. I usually watch TV or something while riding them. They will make you a better and smoother rider! A trainer won't do that for you.
#15
Senior Member
Thread Starter
Very True.
__________________
I have NEVER regretted going on a ride;
I have often regretted not going when I could have!
I am grateful for the headwind that challenged me today!
I am grateful for the tailwind that helped me go fast!
Clydesdales and Athenas Strava Club
https://www.strava.com/clubs/clydesda...bikeforums-net
I have NEVER regretted going on a ride;
I have often regretted not going when I could have!
I am grateful for the headwind that challenged me today!
I am grateful for the tailwind that helped me go fast!
Clydesdales and Athenas Strava Club
https://www.strava.com/clubs/clydesda...bikeforums-net