torque on SRAM crank in bb90 (with conversion)
#1
Going once, going twice..
Thread Starter
Join Date: Jun 2005
Location: VA
Posts: 229
Bikes: Trek Domane
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 5 Post(s)
Likes: 0
Liked 4 Times
in
2 Posts
torque on SRAM crank in bb90 (with conversion)
Anyone know the proper torque or method of setting torque value when using a sram crank on a bb90 bike, with proper GXP sized bearings in the frame of course. Or should I use the indicated torque value on the SRAM crank? It seems very high for the application, but maybe I am missing something. Using enduro's conversion kit.
#3
Going once, going twice..
Thread Starter
Join Date: Jun 2005
Location: VA
Posts: 229
Bikes: Trek Domane
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 5 Post(s)
Likes: 0
Liked 4 Times
in
2 Posts
Gotcha, just wanted to make sure with the change to a BB90/GXP press fit, not GXP native, there weren't any changes like "watch for the wavy washer to go flat then you are done". It seems like a lot of lateral pressure on the bearing centers to be honest, but I'm no expert.