Can you id this BMX bike?
#1
Senior Member
Thread Starter
Join Date: Apr 2005
Location: Down on East End Avenue.
Posts: 1,816
Bikes: Salsa Las Cruces, Burley R&R and a boat load of others.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Can you id this BMX bike?
Can anyone ID this bike? Just bought it for $5.
Interesting points-
170 mm shimano 600 crank, rear brake only, brake cable release in the headtube gusset. Molded plastic race number plate says "Haro"
From the front-- no nameplate
Interesting points-
170 mm shimano 600 crank, rear brake only, brake cable release in the headtube gusset. Molded plastic race number plate says "Haro"
From the front-- no nameplate
Last edited by slagjumper; 04-29-10 at 09:32 PM.
#2
You Know!? For Kids!
That frame looks a lot like an old school Torker. Go to BMX Museum and look at a few. I think the brake release was an add on by someone that used some road parts to make a BMX bike. I used an old Weinmann brake and quick release when I built the Redline Micro Mini for my sons.
__________________
Are you a registered member? Why not? Click here to register. It's free and only takes 27 seconds! Help out the forums, abide by our community guidelines.
Are you a registered member? Why not? Click here to register. It's free and only takes 27 seconds! Help out the forums, abide by our community guidelines.
#3
Senior Member
Thread Starter
Join Date: Apr 2005
Location: Down on East End Avenue.
Posts: 1,816
Bikes: Salsa Las Cruces, Burley R&R and a boat load of others.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Yes toker makes sense to me. I did go to the bmx museum site. I too thought that the brake release was an add on, but it fits really well. Toker was a precursor to haro. The only bad thing that I found is the crank. Just a bit of play on the left side arm. The self extracting design was cool, but not so effective.
#4
You Know!? For Kids!
Get the play out or it will eat itself up. Riding a loose square taper crank arm is not good.
__________________
Are you a registered member? Why not? Click here to register. It's free and only takes 27 seconds! Help out the forums, abide by our community guidelines.
Are you a registered member? Why not? Click here to register. It's free and only takes 27 seconds! Help out the forums, abide by our community guidelines.